Gamma Progression 602 FC 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Gamma Progression 602 FC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Progression 602 FC 16 페이지.
Gamma Progression 602 FC에 대해서도 마찬가지입니다: 소유자 매뉴얼 (16 페이지)

페이지 인쇄

STRINGING THE FRAME

Fixed Clamp Operation

The fixed clamps for the GAMMA 600FC are of a dual

action design. The string clamp and the clamp base

operate independently of one another.

To clamp a string, lift the clamp head and place the string

between the jaws. Depress the clamp head lever to

secure the string. The clamping pressure applied to the

string should be adjusted to provide sufficient pressure

to secure the string when subjected to the desired pulling

tension. The diamond coated gripper plates provide for

increased friction between the clamps and the string to

allow for reduced clamping pressure while securing and

holding the string under tension.

Rotate the winged lock knob clockwise to secure the

clamp base to the turntable.

Reverse the clamping procedure to unlock the string

clamp.

The winged lock knob should be tightened enough to

prevent clamp base slippage on the turntable, when the

desired tension is placed on the string. To go from the

loose position to the clamped position and back, gener-

ally requires about 1/2 to 3/4 quarters of a turn. Although

when stringing at extremely high tensions, additional

tightness may be required.

Note: If the string slips in the string clamp while

tensioning, adjust the gap between the clamp jaws

as per the instructions on page 12.

Clamping the First Main String

To begin stringing the main strings, thread the two ends

of the string through the two center holes at the appro-

priate end of the frame and continue through the oppo-

site center holes. Thread one end of the string through

the adjacent grommet hole and pull excess by hand.

Secure one of the strings using a string clamp.