Gamma PROGRESSION ST 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Gamma PROGRESSION ST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma PROGRESSION ST 19 페이지.

ASSEMBLY INSTRUCTIONS

Machine Base Setup

Remove all parts from the shipping cartons.

Set the base with attached tensioner bar onto

a table or floor.

When purchased with the optional floor stand,

it is more convenient to attach the base to the

floor stand at this point. See instructions

provided with the optional floor stand.

Installing the Turntable

The turntable is located on top of the foam

packing in the the shipping carton.

Insert the center post of the turntable into the

bushing located in the top of the tensioner bar

post.

Installing the Tensioner

Remove the button head screw and washer

located at the end of the tensioner bar with

the 3 mm hex wrench provided. Slide the

tensioner onto the bar, being careful to align

the bar with all of the bearings and the drive

gear with the gear track. Replace the set

screw and washer into the end of the tensioner

bar.

Note: The tensioner bar is equipped with a

tensioner travel stop to limit travel of the

tensioner along the bar. See page 7 for more

details about this feature.