Gamma Progression ST II 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Gamma Progression ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Progression ST II 19 페이지.
Gamma Progression ST II에 대해서도 마찬가지입니다: 소유자 매뉴얼 (17 페이지)

페이지 인쇄

ASSEMBLY INSTRUCTIONS

Remove and Discard Plastic Washers

Winder Bar Installation

To install the winder bar, slide over the post

on the base and secure it with the 2 allen

set screws.

Note: When purchased with the optional ﬂ oor

stand, it is most convenient to attach the base

to the ﬂ oor stand at this point. See instruc-

tions provided with the optional ﬂ oor stand.

Turntable Installation

To install the turntable, position it over the

turntable pin and align the bolts (included in

separate bag) with the holes in the ﬂ ange.

Secure them with the included 6mm allen

wrench.

Note: When purchased with the optional ﬂ oor

stand, it is most convenient to attach the base

to the ﬂ oor stand at this point. See instruc-

tions provided with the optional ﬂ oor stand.

Support Post Installation

To install the support posts you must ﬁ rst

remove the mounting bolt from the mounting

plate that sets inside the central cavity of the

turntable. There are large holes stamped on

the underside of the turntable that allow you to

support the mounting plate with your ﬁ ngers

while removing the mounting bolt.

After removing the mounting bolt, remove

and discard the plastic washers that are

installed for shipping purposes.