Gamma X-6FC 소유자 매뉴얼 - 페이지 6
{카테고리_이름} Gamma X-6FC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-6FC 20 페이지.
Gamma X-6FC에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)
페이지 인쇄
ASSEMBLY INSTRUCTIONS
Nylon
Washers
Support Post Installation
To install the support posts you must fi rst
remove the turntable end cap by grasping
the sides of the end cap and removing it, to
gain access to the inside of the turntable.
Repeat procedure on the opposite side of
the turntable.
If end caps are tight, a fl at blade screw driver
may be used to pry the end caps off.
Remove Mounting Bolts
While holding the mounting plate on the
inside of the turntable remove the support
post mounting bolts.
Note: There are two Nylon washers that are
included for shipping purposes only. Remove
and discard the nylon washers.
Repeat procedure on the opposite side of
the turntable
Installing the Frame Support Posts
Place the support post onto the central slot
of the turntable. While holding the mounting
plate against the inside top surface of the
turntable with your fi ngers, align the hole in
the support post with the hole in the mounting
plate. Install the mounting bolt through the
support post and into the plate by hand and
tighten with the 6 mm hex wrench. Re-install
the turntable end caps.
Repeat procedure on the opposite side of
the turntable
6