Gamma X-ES 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Gamma X-ES에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-ES 19 페이지.

POWER CONNECTION & CONTROLS

ing with Aramid (Kevlar, Technora) hybrid strings or metallic strings, we recommend setting

tension 4-5 lbs. lower than you would normally use for synthetic or natural gut strings.

Caution: To avoid racquet damage, the center posts should not contact the racquet prior to

locking down the support posts.

MOUNTING THE FRAME

Setting Tension

The stringing machine utilizes an adjust-

ment knob along with a digital L.E.D. dis-

play to indicate the tension setting. To set

the tension, rotate the adjustment knob

clockwise to decrease the displayed ten-

sion and counter-clockwise to increase the

displayed tension, until the desired tension

is displayed. Aramid fiber and metallic

strings will generally string up tighter on the

X-ES machine compared to synthetic or

natural gut strings. Therefore, when string-

Adjusting the Frame Support Posts

Loosen the lock bolts of the frame support

posts and space them apart with the frame

support slides separated by the approxi-

mate length of the racquet head. Although it

is not required, it is good practice to center

the support posts on the turntable. Lock one

of the posts in position by tightening the lock

bolt and position the other post until the

frame support slide is positioned near the

inside surface of the racquet frame. Se-

curely tighten the lock bolt of the second

support post.

Tightening the Frame Supports

Tighten the Frame Support Slides by turning

the adjustment knob clockwise until snug

against the racquet frame and slight resis-

tance is felt.

Caution: Overtightening the Center Sup-

ports will stretch the head of the racquet and

could cause racquet damage.