Gamma X-ST 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Gamma X-ST에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma X-ST 19 페이지.
Gamma X-ST에 대해서도 마찬가지입니다: 소유자 매뉴얼 (19 페이지), 소유자 매뉴얼 (19 페이지)

STRINGING THE FRAME

until the "1" or "2" mark on the knob aligns with the line on the knob support. To decrease

tension by 1 or 2 lbs., turn the knob clockwise until the "2" or "1" mark on the knob aligns with

the line on the knob support.

Travel Stop

Setting Tension

The X-ST utilizes a rotary adjusting knob

along with a linear tension scale to indicate

the tension setting. The scale is divided into

3 lb. increments and each 1/3 turn of the ten-

sion knob changes tension by 1 lb. To set the

desired tension, rotate the tension knob and

align the mark on the spring guide with the

desired tension setting on the scale. When

the "0" mark on the knob aligns with the line

on the knob support the tension will be that

indicated on the scale. To increase tension

by 1 or 2 lbs. turn the knob counterclockwise

Tensioner Travel Stop

The tensioner bar is equipped with a tensioner

travel stop to limit travel of the tensioner along

the bar and prevent contact between the

tensioner and the racquet mounting system

while stringing. The travel stop is located

about midpoint along the tensioner bar below

the gear track.

To disengage the stop, pull and hold the knob,

rotate 90 degrees and release. To engage the

stop, repeat the above procedure until the

travel stop pin protrudes beyond the opposite

surface of the tensioner bar.

Setting the Gripper Jaw Spacing

The gripper jaws of the tensioner are adjust-

able to accommodate varying string gauges.

If the string slips through the gripper jaws

while pulling tension, rotate the gripper jaw

adjustment screw counter-clockwise.

If the string is damaged while pulling tension,

rotate the gripper jaw adjustment screw

clockwise.

The jaws will be properly adjusted when

there is enough pressure to securely grip the

string without causing damage to the string.