Gamma Starburst 7x18w 사용자 설명서 - 페이지 8

{카테고리_이름} Gamma Starburst 7x18w에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Starburst 7x18w 11 페이지. 7x18w rgbwa+uv led par

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-

pin only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded

cable of at least 110 ohms resistance. Microphone cable is not DMX cable.

Please refer to the diagram below:

For installations where the DMX cable has to run a long distance or is in an elec-

trically noisy environment, it is recommended to use a DMX terminator. This

helps in preventing corruption of the digital control signal by electrical noise and

reflections. The DMX terminator is simply an XLR plug with a 120 Ω resistor con-

nected between pins 2 and 3, which is then plugged into the output XLR socket

of the last fixture in the chain. Please see illustrations below:

DMX Modes and Configuration

The Starburst Par has multiple DMX modes, sometimes called "personalities", "pro-

files", or as we will use here "modes".

In general, modes with more DMX channels offer a greater level of control or op-

tions but take up more of your output channels on your lighting console or soft-

ware.

Modes with less DMX channels often offer less control, but may be plenty for your

Depending on your needs and control solution, you may not need chan-

needs.

nels for automated programs, strobes, or macros – your console may have great

Starburst 7x18w Par – GAMMA LED Vision

Page 8 of 11