Jakka JRH73/700 사용자 설명서 - 페이지 11

{카테고리_이름} Jakka JRH73/700에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Jakka JRH73/700 14 페이지.

Maintenance

NOTE

JAKKA Controllers for this units have a preset timer to monitor filter occupancy according

to factory set timer. Remote controller informs the user to check the filters. After the

filters are cleaned by the user, filter warning alarm must be reset.

Clean the filter with a vacuum cleaner. To remove dense dust build-ups, prepare

a solution with cold water and natural detergent or soap powder and submerge the

filter in the solution. Later pull out the filter from the solution and leave it to dry. In any

case, do not scrub or apply force on the filter material. After it is completely dry, mount the

filter to the unit, close the service door and tighten the screws thoroughly.

NOTE

It may be handy to keep spare clean and dry filters for quick replacement of dirty filters to

minimize unit downtime for filter maintenance.

Exchanger Maintenance

For best performance, clean up the air exchanger periodically.

If the filters are maintained regularly, clean exchanger at least once in every two years.

HOW TO ACCESS EXCHANGER

To open the service cover that is located on the bottom side of unit, unscrew and

STEP 1

remove out 4 screws that secure the heat recovery exchanger service cover.

While performing removal of service cover make sure heat recovery exchanger

STEP 2

does not fall down.

Vacuum Cleaner

Filter