Green Air Designs Su-27 Flanker 사용 설명서 - 페이지 7

{카테고리_이름} Green Air Designs Su-27 Flanker에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Air Designs Su-27 Flanker 17 페이지.

Step 3 – Taileron Mounts and Servos
Refer to drawings on page "Step 3" for basic build.
Fitting the business end of the flanker.
1. Glue in cross piece at rear of fuse.
2. Drill CENTRALY the wooden blocks for the taileron rods, 2mm drill.
3. Put bends in 12mm from ends (see drawings for clarity).
4. Fit ball link to top of rod. You may need to sand the ends of the rods to
get the ball links on. Make sure they are fitted at the top of rod. Use
just a spot of epoxy to secure.
5. Put bends in control rods for servo horns, centralise servos and trial fit.
6. You will need to thread the rods into the ball links about half their travel
to allow adjustment before ducts fitted.
7. Glue on the servo blocks with the servos centralised and rods attached
to get distance from tailerons.