Decimator MD-CROSS 운영 매뉴얼 - 페이지 16

{카테고리_이름} Decimator MD-CROSS에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Decimator MD-CROSS 16 페이지. Hdmi/(3g/hd/sd) sdi cross converter with scaling and frame rate conversion

페이지 인쇄

Setup: (Has SUB‐MENUs)

Load Defaults

Group 1

When highlighted in the Main Menu, press the ENTER button to enter this sub‐menu.

Press the < and > buttons to move left or right respectively through the 1 menus below and press the

BACK button to go back to the Main Menu when finished.

The current value for each Sub Menu is shown in the Parameter Window.

1. SETUP / LOAD DEFAULTS (Action)

When highlighted in the Menu Window, press the ENTER button to load the default settings. The

device will be reset to the Main Menu Input Status.

Decimator Design warrants that this product will be free from defects in materials and workmanship

for a period of 12 months from the date of purchase. If this product proves to be defective within this

warranty period, Decimator Design, at its discretion, will either repair the defective product without

charge for parts and labour, or will provide a replacement product in exchange for the defective

product.

In order to service under this warranty, you the Customer, must notify Decimator Design of the defect

before the expiration of the warranty period and make suitable arrangements for the performance of

service. The Customer shall be responsible for packaging and shipping the defective product to a

designated service centre nominated by Decimator Design, with shipping charges prepaid. Decimator

Design shall pay for the return of the product to the Customer if the shipment is to a location within

the country in which the Decimator Design service centre is located. The Customer shall be

responsible for paying all shipping charges, insurance, duties, taxes, and any other charges for

products returned to any other location.

This warranty shall not apply to any defect, failure or damage caused by improper use or improper or

inadequate maintenance and care. Decimator Design shall not be obligated to furnish service under

this warranty a) to repair damage resulting from attempts by personnel other than Decimator Design

representatives to install, repair or service the product, b) to repair damage resulting from improper

use or connection to incompatible equipment, c) to repair any damage or malfunction caused by the

use of non‐Decimator Design parts or supplies, or d) to service a product that has been modified or

integrated with other products when the effect of such a modification or integration increases the

time of difficulty of servicing the product.

MD‐CROSS OPERATING MANUAL VERSION 1.0

Main Menu

<==

Sub Menu

Parameter Window

SERVICE WARRANTY