Gamma ST II 소유자 매뉴얼 - 페이지 15

{카테고리_이름} Gamma ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma ST II 17 페이지.

PROBLEM

String slips in clamps

String slips in gripper.

String clamp base slips on turntable.

Tensioner slips on Tensioner Bar

after brake lever is released.

String tension too tight or too loose

With time and use, the clamping surfaces of your machine may become oily or dirty and result in string or clamp

slippage while stringing. Periodic cleaning of the following parts is recommended.

String Clamps

Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner soaked with isopropyl

alcohol between the jaws and rub back and forth. If the build-up is excessive, dismantle the string clamp jaws to

expose the gripping surfaces by removing the adjustment knob. Using a small nylon brush, (such as a toothbrush),

scrub the inside surfaces until all debris is removed. Clean the jaws with isopropyl alcohol and re-assemble.

String Clamp Base

Clean the base of the clamps and the top of the turntable with isopropyl alcohol.

String Gripper

Clean inner gripping surfaces with isopropyl acohol soaked cloth or pipe cleaner.

TROUBLESHOOTING TIPS

For additional assistance, contact Customer Service

SOLUTION

- Adjust gap between jaws

- Clean clamp jaws

- Clean gripper jaws.

- Adjust Gripper Jaw Stop Screw

- Adjust Clamp Base Locking Nut.

- Clean Turntable Clamp Glide Rails

- Adjust tensioner brake lever

- Clean tensioner brake disc

- Check tension using a tension

calibrator and adjust machine calibra

tion if necessary