Gamma ST II 소유자 매뉴얼 - 페이지 5

{카테고리_이름} Gamma ST II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma ST II 17 페이지.

ASSEMBLY INSTRUCTIONS

Installing the Tensioner

Remove the button head screw and washer located at

the end of the tensioner bar with the 3 mm hex wrench

provided. Slide the tensioner onto the bar, being careful

to align the bar with all of the bearings and the drive gear

with the gear track. Replace the screw and washer into

the end of the tensioner bar.

Note: The tensioner bar is equipped with a tensioner

travel stop to limit travel of the tensioner along the bar.

See page 7 for more details about this feature.

Locking the Turntable

The turntable may be locked in any position.

The turntable winged lock knob is packed separately in

the accessory polybag. Install the lock knob into the

threaded hole located on the side of the tensioner bar

post.

Rotate the knob clockwise to lock the turntable, and

counter-clockwise to release the turntable.