Gamma Yealink W52P 전체 사용자 설명서 - 페이지 5

{카테고리_이름} Gamma Yealink W52P에 대한 전체 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Yealink W52P 20 페이지.

How to set up the Yealink W52P

The phone will arrive pre-configured and simply needs to be connected to the internet and powered up.

Your Administrator should know how to do this for you. There are some network/router level settings that

must be applied or the Horizon service will not work. For further details on these please refer to the Horizon

user guide.

Usually the handset that comes in the same box with the base station is pre-associated with it and it is

possible to register up to 5 handsets to a Yealink W52P base station. In case the handset is not already

associated with the base station, or if you would like to associate more handsets to the base station, you

can find the required steps below.

Press the

button on the base station for few seconds. Once the registration LED flashes slowly, this

means that the base station is in the registration mode.



Press "OK" on the handset to enter the main menu



Select Settings  Registration  Register Handset



Once you see the available base station, select it and press "OK"



Enter the registration PIN which is 0000 and press "Done"

Note1: Once the handset is registered it will automatically get a name such as H1.

Note 2: In order to check that the registration was successful and the device is ready to make/receive calls

go to Main Menu  Status  Line Status

In order to de-register a handset from the base station, follow the steps below:

Press "OK" to enter the main menu



Go to Settings  Registration  De-reg. Handset



Enter the PIN which is 0000 and press "Done"

Select the handset that you want to de-register, press "OK" and then "Yes"



Note: You can de-register any handset that is associated with the base station