GREEN BANK WG48200 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} GREEN BANK WG48200에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GREEN BANK WG48200 7 페이지. Lifepo4 battery system

LiFePO4 Battery System

Step 3: The schematic diagram of the parallel connection of six battery packs is shown in Figure 3.

Step 4: The communication terminal (the other end) is connected as shown in Figure 4. Only one communication line

(network cable) is required to connect through the hole between the two batteries. Another one is used as a backup.

Note: After completing the above 4 steps, arbitrarily select the positive and negative poles of one of the battery

packs to output (the upper battery pack or the lower battery pack, you can not select the positive and negative

poles of the two battery packs at the same time). After conﬁrming the correct connection of the inverter, controller

and battery, you can turn on any of the switches and use the battery group happily.

Note: One group of WG48V can be stacked up to 2 layers, and up to 12 in parallel connection.

48V Front view

For pure oﬀ grid system ,the PV awake wire need to be connected with MPPT charge controller if the battery

pack is charged by solar panels only . The connection diagram as below :

LiFePO4 Battery System