Centrosolar Powerstocc ExcellentSeries 짧은 설명서 - 페이지 3

{카테고리_이름} Centrosolar Powerstocc ExcellentSeries에 대한 짧은 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Centrosolar Powerstocc ExcellentSeries 18 페이지. Ps dc storage

Proper use

The Powerstocc DC Storage converts DC current into AC current.

The current can be used for the following:

for consumption

to store the current in the battery of the system (BS DC Storage 11.6 Pb)

for feeds into the public mains grid

The unit may only be used in grid-connected photovoltaic systems within the

permissible power range and under the permissible environmental conditions.

The device is not intended for mobile use.

Inappropriate use can be hazardous and lead to injury or even death of the user

or third parties. Material damage to the device and other equipment can also

occur. The inverter may therefore only be used for its intended purpose.

The Powerstocc DC Storage is equipped with an energy management system.

This system controls based on technical and economic aspects of the use of

electricity generated.

Exclusion of liability

Any use that differs from or goes beyond the stated intended purpose is con-

sidered inappropriate. The manufacturer accepts no liability for any damage

resulting from this. Modifications to the inverter are prohibited. The inverter may

only be used if safe to operate and in technically perfect condition. Any instance

of misuse will cause the termination of the warranty, guarantee and general

liability of the manufacturer.

Only a qualified electrician may open the device. The inverter must be installed

by an electrician who is responsible for observing the applicable norms and

regulations. Work that could affect the electrical power system of the respective

utility company at the site of the solar energy feed-in may only be carried out by

qualified electricians expressly authorised (licensed) by the utility company.

This includes changes to the factory preset parameters. The installer must

always observe the regulations of the utility company. The utility company's

specifications must always be observed when setting the parameters.