KitchenAid 30" Freestanding Range 설치 지침 - 페이지 2

{카테고리_이름} KitchenAid 30" Freestanding Range에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid 30" Freestanding Range 5 페이지. (61cm), (68.6cm), and (76.2cm) indoor/outdoor electric warming drawer
KitchenAid 30" Freestanding Range에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (8 페이지), 설치 지침 매뉴얼 (13 페이지), 설치 지침 (5 페이지), 설치 지침 매뉴얼 (16 페이지)

페이지 인쇄

30" cooktop

30" min. base cabinet

is required. If cabinet has

a drawer, a 3-l/2" depth clearance from the

countertop to the top of the drawer (or other

obstruction)

in base cabinet is required.

36" Cooktop

36" min. base cabinet

is required.

If cabinet

has a drawer, a 3-l/2" depth clearance from the

countertop to the top of the drawer (or other

obstruction)

in base cabinet is required.

Fire Hazard

Do Not obstruct

the flow of combustion

and ventilation

air.

Personal

Injury Hazard

Avoid installing

cabinet

storage

above the

cooking

surface.

If cabinets

are already

installed,

reduce the hazard of reaching

over a heated cooking

surface

installing

a range hood. The range hood

should extend a minimum

of 5 inches out

from the bottom front of the cabinets.

Reaching

over a heated cooking

surface

could result in a serious

burn or other

personal

injury.

Electrical

Shock Hazard

It is the customer's

responsibility:

To contact

a qualified

electrical

installer.

To assure that electrical

installation

adequate

and in conformance

with

National

Electrical

Code ANSI/NFPA

70 -

latest edition and all local codes

and ordinances.

Failure to do so could result in fire: .

electrical

shock or other personal

mjury.

Take special

care when drilling

holes into

the wall for electrical

wiring.

Electrical

wires may be concealed

behind the wall

covering.

Failure to do so could result in fire,

electrical

shock or other personal

injury.

For 30"

cooktop

- 30" min. cabinet

width

above

cooklop

For 36"

cook-lop - 36" min. cabinet width

yabove

cwMop

13"

max.

wper

cabinet

depth

See Note'* for

minimum

clearances

centered

with

Note: 30" min. when bottom of -

cord

between

the

cooktop

and

wood or metal cabinet

cabinets.

protected

by not less

than

114"

flame retardant millboard

covered

with not less than No.

28 MSG sheet steel, 0.015"

Note: Clearances

specified are for combustible

stainless

steel, 0.024"

walls and materials that have a density of 20 or

aluminum

or 0.020" copper.

more pounds per cubic foot. No evaluation of

::;%h:~:;~

;%%

the

clearances

has been made for installations

adjacent to materials that are less than 20

and the bottom o an

unprotected

wood or metal

sheet.

pohnds per cu. ft. or to plastic tiles and sheeting.

For new installations:

30" cooktop:

36" Cooktop:

B 1 ;T;in.

opening

2-5/8"

min. cabinet

space to backsplash

or vertical

wall

2-318" min. space to

front edge of

countertop

5-114"

min. cabinet

space both sides of

cooktop

from a

combustible

surface

18-314"

min.

opening

depth

33-l/4"

min.

opening

width

2-5/8" min. cabinet

space to backsplash

or vertical

wall

4-5/8"

min. cabinet

space both sides of

cooktop

from a

combustible

surface

For reolacement installations:

30" cooktop:

36" Cooktop:

1 k3l4"

min., 20-518" max.

opening

depth

18-314" min., 20-518"

opening

depth

26-112" min., 29518" max.

opening

width

33" min., 34-718" max.

opening width

Mobile home installation

The installation of this cooktop must conform to the

Manufactured

Home Construction

and Safety

Standards, Title 24 CFR, Pat-l 3280 (formerly the

Federal Standard for Mobile Home Construction

and

Safety, Title 24, HUD Part 280); or when such

standard is not applicable, the Standard for

Manufactured

Home Installations

1982

(Manufactured

Home Sites, Communities

and

Setups), ANSI A225, l/NFPA 501 A -

1987, or latest

edition, or with local codes.

Copies of the standards listed may be obtained from:

* National

Fire Protection

Association

Batterymarch

Park

Quincy,

Massachusetts

02269

* American

Gas Association

1515 Wilson Boulevard

Arlington,

Virginia

22209

Before you start...

WARNING: If the information in this

manual is not followed exactly, a

fire or explosion may result

causing property damage, personal

injury or death.

- Do Not store or use gasoline or

other flammable vapors and

liquids in the vicinity of this or

any other appliance.

- WHAT TO DO IF YOU SMELL

GAS

Do Not try to light any

appliance.

Do Not touch any electrical

switch; do not use any phone

in your building.

Immediately call your gas

supplier from a neighbor's

phone. Follow the gas

supplier's instructions.

If you cannot reach your gas

supplier, call the fire

department.

- Installation and service must

be performed by a qualified

installer, service agency or the

gas supplier.

Proper installation

is your responsibility.

Make sure

you have everything

necessary for correct

installation.

It is the responsibility

of the installer to

comply with the installation clearances

specified on

the seriavrating

plate. The serial/rating

plate can be

found on the bottom of the cooktop burner box.

Check location

where cooktop will be installed. The

location should be away from strong draft areas,

such as windows. The cooktop should be located for

convenient

use in the kitchen.

ALL OPENINGS

IN THE WALL OR FLOOR WHERE

THE COOKTOP

IS TO BE INSTALLED

MUST BE

SEALED.

Grounded

electrical

outlet is required. See

"Electrical requirements."

Proper gas supply

connection

must be available.

See "Gas supply requirements."

Countertop

opening

dimensions

that are shown

must be used. Given dimensions provide required 0"

clearance.

Cabinet

construction:

This appliance is designed

for use in a base cabinet with a depth of 24"

The

maximum depth for overhead cabinets is 13". The

minimum vertical clearance between the cooking

surface and the overhead cabinets is 30". Overhead

cabinets installed at either side of the appliance

must

be a minimum of 18" above the cooking surface. The

minimum distance between the front edge of the

countertop and the front edge of the cooktop is 3/4".

The minimum horizontal distance between the

overhead cabinets above the appliance are shown

for your model number.

New installations

follow minimum dimensions given.

Replacement

installations

Be sure that front

edge of cooMop is at least 1 -l/2" back from front

edge of countertop.

When installing

cooktop

over a built-under

oven.

Do Not fasten cooktop to countertop with clamps.

Cooktop then will be easy to remove if servicing is

ever necessary.

Note: The sealed gas cooktop is manufactured

for

use with NATURAL gas. Conversion to L.P. gas can

be made with Kit No. 4175385, available from your

KitchenAid dealer or authorized parts distributor.

Important:

Observe

all governing

codes and

ordinances.

Failure to meet codes and

ordinances

could

lead to fire or electrical

shock.

Panel A