Major Manufacturing ADAMS RITE 4502 Series 사용 설명서 - 페이지 7

{카테고리_이름} Major Manufacturing ADAMS RITE 4502 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Major Manufacturing ADAMS RITE 4502 Series 9 페이지. Lip strike template

페이지 인쇄

Place the router bit in the starting hole and with firm

control of the router follow the HIT-40 template and feed

the router slowly in a CLOCKWISE DIRECTION.

Route in a line up the front portion of the jamb staying just

inside the frame to complete the opening. ( If you route

out the front of the frame at this point, there will be a large

gap in front of the strike that will be visible. ) This area

will be routed out after the bit has been adjusted to a new

cutting depth.

IMPORTANT!! DO NOT ROUTE THROUGH THE

FRONT EDGE OF THE JAMB. MAKE THE VERTICLE

CUT ABOUT 3/8" INSIDE THE FRONT EDGE.

facturing

cut through in the step above. Adjust the depth of the

router to cut the

thickness of the jamb material only, this should be a

cut depth of only about 1/8 inch. Use the router to

nibble away this area.

Page 7

Make sure the base of the

router is held flat on the

routing template. When com-

pleted with the cut, turn the

router off and wait for the bit to

come to a complete stop be-

fore removing it from the tem-

plate. Failure to do so may

This is the area you did not