Major Manufacturing HIT-41 SERIES 사용 설명서 - 페이지 10

{카테고리_이름} Major Manufacturing HIT-41 SERIES에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Major Manufacturing HIT-41 SERIES 12 페이지. Electric strike templates

If the installation calls for a round corner faceplate,

lightly touch up this area with a round file.

If you are installing a strike with a square

faceplate, square these with a flat file.

Now is the time to drill out the holes needed for

the factory mounting tabs. Use a 3/16" drill bit for

this job.

Note: the template in this case uses two mounting

holes top and bottom, some strikes only require

one hole so your template may vary from the

picture.

Counter sink the mounting holes.