Gamma Sports 602FC 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Gamma Sports 602FC에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamma Sports 602FC 9 페이지.

페이지 인쇄

STRINGING THE FRAME

ally requires about 1/2 to 3/4 quarters of a turn. Although when stringing at extremely high

tensions, additional tightness may be required.

string while tensioning the string. Simply insert the loose end into the tear drop shaped holes

and slide the string toward the point of the hole.

Base Clamp Operation

Rotate the lever lock clockwise to secure

the clamp base to the turntable.

Reverse the clamping procedure to unlock

the string clamp.

The lever should be tightened enough to

prevent clamp base slippage on the turn-

table, when the desired tension is placed

on the string. To go from the loose position

to the clamped position and back, gener-

Getting Started

To begin stringing the main strings, thread

the two ends of the string through the two

center holes at the appropriate end of the

frame and continue through the opposite

center holes. Thread one end of the string

through the adjacent grommet hole and pull

excess by hand.

Secure one of the strings using a string clamp.

Handy tip: The tear drop shaped holes

towards the back of the shoulder supports

are handy for holding the loose end of the

Gripping the String

While holding the tension bar slightly above

horizontal, wrap the free string clockwise

around the gripper drum once and position

between the gripper jaw.

Gently turn the gripper clockwise while

squeezing the jaws together until all slack

in the string is removed.

Note: For proper operation, the string grip-

per jaw must be in the position shown. The

tension in the string provides the clamping

force to the jaws.

STRINGING THE FRAME

WARNING:

TO AVOID INJURY, KEEP FINGERS AWAY

FROM GRIPPER JAWS WHILE TENSIONING STRING.

Pulling Tension

While securely holding the string gripper drum

with your hand, lift the tension bar above

horizontal and gently lower the bar under its

own weight. If the tension bar drops below

horizontal, repeat the above action until the

bar comes to rest parallel to the racquet.

When the correct tension is attained, the drop

weight bar will rest horizontally as shown. For

accurate tensioning, it must be lowered and

come to rest at horizontal without assistance.

Manually forcing the tension bar to the hori-

zontal position will greatly increase the string

tension and may result in racquet damage.

If the tension bar comes to rest above hori-

zontal, release the string by lifting the bar

and re-pull the string.

Clamping the First Main String

Secure the tensioned main string using the

second ﬁ xed clamp. Repeat the procedure

for all of the remaining main strings and tie off

at the appropriate hole following the racquet

manufacturers speciﬁ cation.

Follow the racquet manufacturer's recom-

mended stringing pattern for one or two piece

stringing. This will determine the starting

point for the cross strings. If applicable, tie

the ﬁ rst cross string using an appropriate

starting knot.