KitchenAid Architect Series II KECC566RSS 설치 매뉴얼 - 페이지 6
{카테고리_이름} KitchenAid Architect Series II KECC566RSS에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid Architect Series II KECC566RSS 16 페이지. Kitchenaid architect series ii kecc568rps: install guide
KitchenAid Architect Series II KECC566RSS에 대해서도 마찬가지입니다: 치수 (1 페이지)
페이지 인쇄
For 15" (38.1 cm) model only:
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 12 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
For all models except 15" (38.1 cm) model:
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground cooktop.
Failure to follow these instructions can result in death,
fire, or electrical shock.
This cooktop is manufactured with a frame connected, green or
bare ground wire. Connect the cooktop cable to the junction box
through the UL listed or CSA approved conduit connector.
6
Make Electrical Connection
1. Disconnect power.
2. Remove junction box cover, if present.
3. Connect the flexible cable conduit from the cooktop to the
junction box using a UL listed or CSA approved conduit
connector.
4. Tighten screws on conduit connector if present.
5. See "Electrical Connection Options Chart" to complete
installation for your type of electrical connection.
Electrical Connection Options Chart
For cooktops with a 4-wire cable:
If your home has:
4-wire
For cooktops with a 3-wire cable:
3-wire
If your cooktop has:
4-wire
"
(1.3 cm)
½"
3-wire
(1.3 cm)
"
(1.3 cm)
4-wire
"
(1.3 cm)
½"
(1.3 cm)
3-wire
"
(1.3 cm)
Go to Section:
4-Wire Cable
from Home
Power Supply to
4-Wire Cable
from Cooktop
4-Wire Cable
from Home
Power Supply to
3-Wire Cable
from Cooktop
3-Wire Cable
from Home
Power Supply to
4-Wire Cable
from Cooktop
3-Wire Cable
from Home
Power Supply to
3-Wire Cable
from Cooktop