KitchenAid GCI3061 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} KitchenAid GCI3061에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid GCI3061 12 페이지. 30" (76.2 cm) electric induction cooktop
KitchenAid GCI3061에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지)
페이지 인쇄
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Tape measure
Flat-blade screwdriver
Phillips head screwdriver
Hand or electric drill
Level
Parts supplied
Brackets (2)
2 " (6.4 cm) clamping screws (4)
#8 x
" (9.5 mm) sheet metal screws (4)
Parts needed
A UL listed or CSA approved strain relief
UL listed wire connectors
Check local codes. Check existing electrical supply. See
"Electrical Requirements."
It is recommended that all electrical connections be made by a
licensed, qualified electrical installer.
Location Requirements
Make sure you have everything needed for correct installation. It is
the responsibility of the installer to comply with the installation
clearances specified in these instructions.
IMPORTANT: Observe all governing codes and ordinances. When
installing cooktop, use minimum dimensions given.
To eliminate the risk of burns or fire by reaching over the
heated surface units, cabinet storage space located above the
surface units should be avoided. If cabinet storage is to be
provided, the risk can be reduced by installing a range hood
that projects horizontally a minimum of 5" (12.7 cm) beyond
the bottom of the cabinets.
It is the installer's responsibility to comply with installation
clearances specified on the model/serial rating plate. The
model/serial rating plate is located on the underside of the
cooktop burner box.
30" (76.2 cm) cooktop model/serial rating plate location
(models GCI3061, ICI500, KICU500)
A. Model/serial rating plate location
2
INSTALLATION REQUIREMENTS
Marker or pencil
Pliers
¼" drill bit
Jigsaw
A
Check the cooktop base for an approved installation label.
Verify approved oven model number that can be installed with
your cooktop model number. If you don't find this label, your
cooktop should not be used over a built-in oven.
Ovens approved for this type of installation will have an
approval label located on the top of the oven. If you do not
find this label, contact your dealer to confirm that your oven is
approved. Refer to oven manufacturer's Installation
Instructions for approval for built-in undercounter use and
proper cutout dimensions.
When installing cooktop over an undercounter built-in oven,
do not fasten cooktop to countertop with clamps or seal
cooktop to countertop. This will make the cooktop easier to
remove if future servicing becomes necessary.
Use the countertop opening dimensions that are given with
these Installation Instructions. Given dimensions are minimum
clearances and provide 0" (0 cm) clearance.
Grounded electrical supply is required. See "Electrical
Requirements" section.
Product Dimensions
30" (76.2 cm) Cooktops
B
A
Models GCI3061
Model ICI500
A. 21
" (54.1 cm)
A. 20 " (51.0 cm)
B. 3
" (77.0 cm)
B. 3
C. 2 " (6.0 cm)
C. 2 " (6.0 cm)
C
Models KICU500
and KICU509
A. 21
" (54.1 cm)
" (77.0 cm)
B. 3
" (78.2 cm)
C. 2 " (6.0 cm)