KitchenAid ICS5 Series 프로판 전환 지침 - 페이지 3

{카테고리_이름} KitchenAid ICS5 Series에 대한 프로판 전환 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid ICS5 Series 20 페이지. Lp gas

페이지 인쇄

Tools and Parts

Gather the required tools and parts necessary for correct LP gas

conversion.

Tools needed

■

Flat-blade screwdriver

³⁄₃₂" (#0 [2.0 mm]) flat-blade screwdriver (screwdriver shaft

■

must be a minimum of 2" [5.1 cm] long)

■

Adjustable wrench

■

7.0 mm nut driver

■

7.0 mm wrench

■

T10 Torx

®†

adapter

Parts needed

For models KCGS550ESS, KCGS556ESS, KCGS950ESS and

KCGS956ESS use the following parts:

■

LP orifice package (W10676662)

■

Conversion instructions (W10597146A)

For all other models use the following parts:

■

LP orifice package (W10676661)

■

Conversion instructions (W10597146A)

High Altitude Conversion

To convert the cooktop for elevations above 6,560 ft (1999.5 m),

order a High Altitude Conversion Kit.

For models KCGS550ESS, KCGS556ESS, KCGS950ESS and

KCGS956ESS use the following parts:

■

Part Number W10679116 - LP high altitude

■

Part Number W10679118 - Natural gas high altitude

For all other models use the following parts:

■

Part Number W10679114 - LP high altitude

■

Part Number W10679113 - Natural gas high altitude

To order, see the "Assistance or Service" section of the User Guide.

IMPORTANT: Gas conversions from Natural gas to LP gas must

be done by a qualified installer. Before proceeding with

conversion, shut off the gas supply to the cooktop prior to

disconnecting the electrical power.

WARNING

This conversion kit shall be installed by a

qualified service agency in accordance

with the manufacturer's instructions and

all applicable codes and requirements of

the authority having jurisdiction. If the

information in these instructions is not

followed exactly, a fire, explosion or

production of carbon monoxide may

result causing property damage, personal

injury or loss of life. The qualified service

agency is responsible for the proper

installation of this kit. The installation is

not proper and complete until the

operation of the converted appliance is

checked as specified in the

manufacturer's instructions supplied with

this kit.

†®TORX is a registered trademark of Acument Intellectual Properties, LLC.

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure

gas pressure does not exceed 14" (36 cm) water

column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and

authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Convert from Natural Gas to LP Gas

1. Turn manual shutoff valve to the closed position.

A. To cooktop

B. Shutoff valve (closed position)

C. Gas supply line

2. Unplug cooktop or disconnect power.

To Convert Gas Pressure Regulator

A. Access cap

B. Rear of cooktop

C. Gas pressure regulator

D. Gas flow

3. Determine the type of regulator you have:

Style 1: The cap has a slot and "NAT" printed on it.

Remove access cap by using a flat-blade screwdriver or coin,

turning the access cap counterclockwise.