KitchenAid ICS6 Series 프로판 전환 지침 - 페이지 9

{카테고리_이름} KitchenAid ICS6 Series에 대한 프로판 전환 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. KitchenAid ICS6 Series 20 페이지. Lp gas

페이지 인쇄

Lighting the Electronic Igniters

The cooktop burners use electronic igniters in place of standing

pilots. When the cooktop control knob is pushed in, the system

creates a spark to light the burner. This sparking continues until

the control knob is turned to the desired setting.

To Check Operation of the Cooktop Burners:

1. Push in and turn knobs to the ignition position (see the User

Guide for additional information). The cooktop burner flame

should light within 4 seconds. The first time a burner is lit, it

may take longer than 4 seconds to light because of air in the

gas line. Do not leave the knob in the ignition position after

the burner lights.

2. If burners do not light properly, turn the control knob to the

Off position. Make sure the burner caps are in the proper

position.

3. Check that the power supply cord is plugged in. Check that

the circuit breaker has not tripped or the household fuse has

not blown.

4. Check that the shutoff valve is in the open position.

5. Check burner operation again.

If one or all of the burners do not light at this point, see

"Assistance or Service" section in the User Guide.

Flame Height Adjustment

Each burner flame has been factory set to the lowest position

available to provide reliable and constant reignition of the burner.

However, each burner can be adjusted.

NOTE: If your model number begins with KGCS5 or KGCS9, call

service, as this operation will require opening the unit.

To Adjust:

The flame can be adjusted using the adjustment screws

underneath the control knob.

NOTE: Check the Use and Care Guide for information on each

burner to determine whether they are single or dual flame. Adjust

the valves accordingly.

Adjustment for Single Valve

1. Set the burner flame to LO.

2. Remove the control knob.

3. Hold knob stem with a pair of pliers. Use a ³⁄₃₂" (#0 [2.0 mm])

flat-blade screwdriver to turn the screw located within the

shaft of the control knob stem until the flame is the proper

size.

³⁄₃₂

" (#0 [2.0 mm]) flat-blade screwdriver

(screwdriver shaft must be a minimum of

2" [5.1 cm] long)

B. Control knob stem opening

C. Adjustment screw location

4. For LP gas conversion:

Completely tighten screw "C" to set the minimum flame

height.

For Natural gas conversion:

Tighten screw "C" to reduce flame height. Loosen screw to

increase flame height. See "Complete Burner Adjustment"

section.

5. Replace the control knob.

6. Test the flame by turning the control from LO to HI, checking

the flame at each setting.

Adjustment for Dual Valve

To Adjust Inner Crown Flame:

1. Set the inner crown flame to LO.

A. Inner crown

B. Outer crown

2. Remove the control knob.

3. Remove the black rubber grommet.

4. Using needle-nose pliers, remove the gray shield inside the

burner valve opening.

A. Control knob

B. Black rubber grommet

C. Gray shield