Centurion R5 빠른 설정 매뉴얼 - 페이지 14

{카테고리_이름} Centurion R5에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion R5 19 페이지. Rotary swing gate operator
Centurion R5에 대해서도 마찬가지입니다: 빠른 설정 매뉴얼 (2 페이지), 빠른 설정 매뉴얼 (17 페이지)

페이지 인쇄

1. Get into Programming Mode

At this moment release the TEST button to select feature

number 2. (L2 will turn off, and L1 will keep on flashing 2 times

and pausing to indicate that feature number 2 is selected).

NOTE: The STATUS of the Feature is not changed yet, the

feature has only been selected to be changed!

If an incorrect Feature is selected, then remove and re-

apply power and repeat the procedure.

To change the STATUS value of a Feature: (IM page 31)

Press and hold the TEST button while monitoring the

STATUS light:

(Continues from above example to set outoclose to ON status).

The L1 light will flash once and pause,

At this moment release the TEST button to give a

STATUS value of 1. The AUTOCLOSE feature has been set to

NOTE: Only after setting the STATUS, would the

AUTOCLOSE be turned ON.

(L2 will come back on, indicating that the STATUS has been

set.)

To change the COUNT value of a Feature: (IM page 31)

Press and hold the TEST button while monitoring the

STATUS light:

After a slight pause, the STATUS light will start flashing

regularly:

At this moment release the TEST button to give a COUNT

value of 10. This could for example be the preflash time.

(L2 will come back on, indicating the COUNT value has

been set).

XIT

Remove the SET link.

Flash (1), Flash (2), Flash (3), Flash (4), Flash (5),

Flash (6) ................ Flash (9), Flash (10).

ROGRAMMING

ODE