Centurion SMART GUARD air 사용 설명서 - 페이지 9
{카테고리_이름} Centurion SMART GUARD air에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion SMART GUARD air 12 페이지. High security keyless access control
Centurion SMART GUARD air에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)
페이지 인쇄
19. Typical connection diagram
Refer to this diagram only if an external 12V power source is to be
used* Even though an external power supply will provide a more or
less unlimited duty cycle, there will be no autonomy whatsoever in
the event of a power failure.
* Should an external 12V power supply be used, the
power selection link must be moved to bridge the pin
marked '12 Volt' with the common (centre) pin.
From external
12V DC
power supply
The supply voltage should not exceed 12V DC
20. Glossary of terms
Access code
The code number the user will enter to gain access. It can range
in length from one to ten digits.
Address/ User address
The location where the user's code is stored in the keypad
memory. It can be any number between 1 and 999.
It should be recorded, allowing the user code to be removed
from the memory later if necessary.
Master Code
The code number required for programming the keypad.
It is stored in user address 0.
The default Master Code of a new unit is
For security reasons, the installer should change
this code at the time of installation.
Refer to Section 7 for instructions on how to change
the Master Code.
Enter key
#
In order to gain access, the user code must be followed by a
21. Important installation information
Complete the installation information below for future reference.
Keep this manual in a safe place.
Master Code
Channel 1 activates
Channel 2 activates
Channel 3 activates
Channel 4 activates
Channel 5 activates
Channel 6 activates
Channel 7 activates
Channel 8 activates
Channel 9 activates
Channel 10 activates
Channel 11 activates
Channel 12 activates
Channel 13 activates
Channel 14 activates
Channel 15 activates
Installers information:
Name:
Mobile number:
Email address:
Physical address:
In1
1 2
3 4
#
.