Major tech MT957 사용 설명서 - 페이지 12

{카테고리_이름} Major tech MT957에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Major tech MT957 17 페이지. Lcr meter

INDUCTANCE MEASUREMENT

WARNING: To avoid electric shock, disconnect both test probes from

any source of voltage before making a inductance measurement.

If you wish to measure inductance, set the function switch to the

10mH.

Insert the black test lead banana plug into Negative input jack for

inductance measurements and the red test lead banana plug into

Negative input jack for inductance measurements.

Touch the inductance Probe head to the part which inductance you

wish to measure. Keep the probe touching the part under test until

the reading stabilizes (about 10 seconds).

Read the temperature in the display. The digital reading will indicate

the proper decimal point and value.

WARNING: To avoid electric shock, be sure the inductance has been

removed before changing to another measurement function.

WARNING: To avoid electric shock, disconnect the test leads from any

source of voltage before removing the battery door.

When the batteries become exhausted or drop below the operating

voltage, "

display. The battery should be replaced.

Follow instructions for installing battery. See the Battery Installation

section of this manual.

Dispose of the old battery properly.

WARNING: To avoid electric shock, do not operate your meter until the

battery door is in place and fastened securely.

" will appear in the right-hand side of the LCD