Major tech MT22 사용 설명서 - 페이지 14
{카테고리_이름} Major tech MT22에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Major tech MT22 16 페이지. 1000v ac/dc multimeter
![Major tech MT22 사용 설명서](/uploads/products/server2/2055873/2055873.jpg)
6.13. TEMPERATURE MEASUREMENTS
WARNING: To avoid electric shock, disconnect both test probes
from any source of voltage before making a temperature
measurement.
1.
If you wish to measure temperature in °F, set the function switch to
the °F range. If you wish to measure temperature in °C, set the
function switch to the °C range.
2.
Insert the black test lead banana plug into the negative (COM) jack
and the red test lead banana plug into the positive (V) jack, making
sure to observe the correct polarity.
3.
Touch the Temperature Probe head to the part whose temperature
you wish to measure. Keep the probe touching the part under test
until the reading stabilizes (about 30 seconds).
4.
Read the temperature on the display. The digital reading will indicate
the proper decimal point and value.
WARNING: To avoid electric shock, be sure the thermocouple has
been removed before changing to another measurement function.
6.14. REPLACING THE BATTERY
WARNING: To avoid electric shock, disconnect the test leads from
any source of voltage before removing the battery door.
1.
When the batteries become drained or drop below the operating
voltage, "BAT" will appear in the right-hand side of the LCD display.
The battery should be replaced.
2.
Follow instructions for installing battery. See the Battery Installation
section of this manual.
3.
Dispose of the old battery properly.
WARNING: To avoid electric shock, do not operate your meter until
the battery cover is in place and fastened securely.
6.15. BATTERY INSTALLATION
WARNING: : To avoid electric shock, disconnect the test leads from
any source of voltage before removing the battery cover.
1.
Disconnect the test leads from the meter.
2.
Open the battery cover by loosening the screw using a phillips head
screwdriver.
10 14