Centurion SMART GUARD air 사용 설명서 - 페이지 5
{카테고리_이름} Centurion SMART GUARD air에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion SMART GUARD air 12 페이지. High security keyless access control
Centurion SMART GUARD air에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)
페이지 인쇄
Enter the following keystrokes:
1. Enter Program Mode
2. Select Delete Menu
3. Enter user address
4. Enter user address
5. Exit Delete Menu
6. Exit Program Mode
10. Pairing
A clear distinction must be made between the Pairing Menu and the
Adding Menu.
The Adding Menu will be used whenever a new code is to be added to
the SMARTGUARDair's memory. This will in turn create a means of
'unlocking' transmission to a designated receiver; a valid code will have
to be entered before the unit will begin transmitting.
Conversely, the Pairing Menu allows the user to pair the
SMARTGUARDair to one or more CENTURION code-hopping receivers
within the specified range of transmission, comparable to learning a
remote control into a receiver.
Enter the following keystrokes:
1. Enter Program Mode
2. Select Pairing Menu
3. Enter channel
4. Enter receiver type*
5. Enter transmission time [0 - 90 seconds]
6. Exit Pairing Menu
7. Exit Program Mode
0
*
for NOVA receiver
1
for future receiver
Once transmission has ended, repeat Steps 3 and 4 for additional
channels.
The maximum transmission time is 90 seconds
If no receiver is specified, NOVA is selected by default
The default transmission duration is eight seconds
Additional functionality, such as pulsing or latching outputs is
handled by the associated receiver
Example:
Pair Channel 1 with a NOVA receiver, allowing for a transmission
duration of ten seconds.
Master Code=
Enter the following keystrokes:
1. Enter Program Mode
2. Select Pairing Menu
3. Enter channel
4. Enter receiver type
5. Enter transmission time
6. Exit Pairing Menu
7. Exit Program Mode
11. Setting the anti-hack parameters
The following procedure sets the number of wrong access codes that
the SMARTGUARDair will accept before becoming inactive, as well as
the time for which it will remain inactive. The factory default for wrong
access codes is three, while the default reset time is 60 seconds.
Enter the following keystrokes:
1. Enter Program Mode
2. Select Lockout Menu
3. Enter number of codes
4. Enter Reset Time
5. Exit Program Mode
Example:
Set wrong code alarm to activate after five incorrect codes have
been entered. The unit must reactivate after 30 seconds.
Master Code=
Enter the following keystrokes:
1. Enter Program Mode
2. Select Lockout Menu
3. Enter number of codes
4. Enter Reset Time
5. Exit Program Mode
2
5
8
3
Channel
0
1 2
3 4
3
1
0
1
4
Wrong codes
Seconds
1 2
3 4
4
5
3
1
2
3
4
4
7
Master Code
OR
1
1
2
3
4
0
Master Code
1
2
3
4
0
Indicator LEDs
Indicator LEDs
Indicator LEDs
Indicator LEDs
Indicator LEDs