Centurion SMARTGUARD 설치 매뉴얼 - 페이지 5

{카테고리_이름} Centurion SMARTGUARD에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Centurion SMARTGUARD 12 페이지.

페이지 인쇄

9. Setting the output timers

Sets the output pulse time of the output channels. Default setting is

one second pulse.

Enter the following keystrokes:

1. Enter Program Mode

2. Select Output Menu

3. Enter channel

4. Enter pulse time

5. Exit Output Menu

6. Exit Program Mode

Once transmission has ended, repeat Steps 3 and 4 for additional

channels.

 A pulse time of zero seconds will give latched output

 Maximum pulse time is 255 seconds

Example:

Pair Channel 1 with a NOVA receiver, allowing for a transmission

duration of ten seconds.

Master Code=

Enter the following keystrokes:

1. Enter Program Mode

2. Select Output Menu

3. Enter Output channel

4. Enter pulse time

5. Exit Output Menu

6. Exit Program Mode

10. Setting the anti-hack parameters

The following procedure sets the number of wrong access codes that

the SMARTGUARD will accept before becoming inactive, as well as

the time for which it will remain inactive. The factory default for wrong

access codes is three, while the default reset time is 60 seconds.

Enter the following keystrokes:

1. Enter Program Mode

2. Select Lockout Menu

3. Enter number of codes Wrong codes

4. Enter Reset Time

5. Exit Program Mode

 If the Number of wrong codes is set to zero, the unit will

accept an unlimited number of wrong codes.

 If the Reset time is set to zero, the unit can only be reset by

removing the power.

Example:

Set wrong code alarm to activate after five incorrect codes have

been entered. The unit must reactivate after 30 seconds.

Master Code=

Enter the following keystrokes:

1. Enter Program Mode

2. Select Lockout Menu

3. Enter number of codes

4. Enter Reset Time

5. Exit Program Mode

Channel

Seconds

1 2

3 4

Seconds

1 2

3 4

Master Code

Indicator LEDs