IKEA KULINARISK 사용자 설명서 - 페이지 23

{카테고리_이름} IKEA KULINARISK에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA KULINARISK 32 페이지. Oven with steam feature
IKEA KULINARISK에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (36 페이지), 매뉴얼 (36 페이지), 사용 설명서 (48 페이지), 사용 설명서 (36 페이지), 매뉴얼 (24 페이지), 설치 지침 매뉴얼 (36 페이지), 매뉴얼 (20 페이지), 매뉴얼 (44 페이지), 사용자 설명서 (36 페이지), 매뉴얼 (40 페이지), 매뉴얼 (40 페이지), 사용자 설명서 (20 페이지), 매뉴얼 (37 페이지), 매뉴얼 (32 페이지), 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (21 페이지), 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 (40 페이지), 매뉴얼 (20 페이지), 매뉴얼 (32 페이지), 매뉴얼 (36 페이지), 매뉴얼 (17 페이지)

페이지 인쇄

ENGLISH

Steam generation system

Caution! Dry the steam

generator after each use.

Remove the water with the

sponge.

Remove the limescale with water

and vinegar.

Caution! Chemical de-scaling

agents can cause damage to the

enamel. Follow the instructions of

the manufacturer.

1. To clean the water drawer and the

steam generator, put the water and

vinegar mixture (approximately 250 ml)

through the water drawer into the steam

generator. Wait for approximately 10

minutes.

2. Remove the water and vinegar with the

sponge.

3. Put clean water (100 - 200 ml) into the

water drawer to flush the steam

generation system.

4. Remove the water from the steam

generator with the sponge and rub it

dry.

5. Keep the door open to let the appliance

dry fully.

Removing and installing the door

The oven door has three glass panels.You

can remove the oven door and the internal

glass panels to clean them.

The oven door can close if you

try to remove the glass panels

before you remove the oven

door.

Caution! Do not use the

appliance without the glass

panels.

1. Open the door fully.

2. Fully press the clamping levers (A) on

the two door hinges.

3. Close the oven door to the first opening

position (approximately 70° angle).

4. Hold the door with one hand on each

side and pull it away from the appliance

at an upwards angle.

5. Put the door with the outer side down

on a soft cloth on a stable surface. This

is to prevent scratches.

6. Hold the door trim on the top edge of

the door at the two sides and push

inwards to release the clip seal.

7. Pull the door trim to the front to remove

it.

8. Hold the door glass panels on their top

edge one by one and pull them up out

of the guide.

9. Clean the glass panel with water and

soap. Dry the glass panel carefully.