Jalousie-Welt Jupiter 운영 및 유지보수, 배송, 포장 풀기 및 설치 지침 - 페이지 11

{카테고리_이름} Jalousie-Welt Jupiter에 대한 운영 및 유지보수, 배송, 포장 풀기 및 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Jalousie-Welt Jupiter 20 페이지. Terrace awning

페이지 인쇄

The awning meets the wind class rating when the manufacturer's recommended number and type of the

mounting brackets were mounted with the correct mounting anchors. Before starting installation make sure

that the mounting surface is suitable for the mounting ‒ if were found the deviations of the surface strength,

then order more mounting brackets - (number of mounting brackets ,in standard, for Wall mounting Concrete

C20/25).

Mark the brackets and drill the holes (position of the brackets in the following figure and description:

mounting

roller tube

bracket

support

Position A

max 10 cm

2 brackets - both brackets should be placed at a distance of not more than 10 cm from the outer edge of the

arm bracket (position A), symmetrically on both sides of the awning. If between the arm bracket and the

roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the

inner edge of the arm bracket (position B), symmetrically on both sides of the awning.

3 brackets ‒ two brackets should be placed at a distance of not more than 10 cm from the outer edge of the

arm bracket (position A), symmetrically on both sides of the awning. If between the arm bracket and the

roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the

inner edge of the arm bracket (position B), symmetrically on both sides of the awning. One of the brackets

should be placed in the middle of the width of the awning (position D) with a deviation of 5 cm or when a

holder of the roller tube (item 3.12 pos. 29) is in the middle next to it.

4 brackets - two brackets should be placed at a distance of not more than 10 cm from the outer edge of the

arm bracket (position A), symmetrically on both sides of the awning. If between the arm bracket and the

roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the

inner edge of the arm bracket (position B), symmetrically on both sides of the awning. The other two

brackets should be placed, symmetrically on both sides of the awning, between the arm bracket and center

of the awning width (position C).

5 brackets - two brackets should be placed at a distance of not more than 10 cm from the outer edge of the

arm bracket (position A), symmetrically on both sides of the awning. If between the arm bracket and the

roller tube support there is not enough space, the brackets should be placed no more than 5 cm from the

inner edge of the arm bracket (position B), symmetrically on both sides of the awning. The other two

brackets should be placed, symmetrically on both sides of the awning, between the arm bracket and center

of the awning width (position C). One of the brackets should be placed in the middle of the width of the

awning (position D) with a deviation of 5 cm or when a holder of the roller tube (item 3.12 pos. 29) is in the

middle next to it.

Another brackets - should be symmetrically, taking into account the fact that the biggest load of support bar

are around arm brackets.

mounting

arm

bracket

Position B

max 5 cm

mounting

bracket

Position C

roller tube

support bar

± 5 cm

page: 11 / 20

mounting

center of

bracket

the awning

Position D

width

± 5 cm