IKEA KULINARISK 매뉴얼 - 페이지 24

{카테고리_이름} IKEA KULINARISK에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA KULINARISK 32 페이지. Oven with steam feature
IKEA KULINARISK에 대해서도 마찬가지입니다: 사용 설명서 (20 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (16 페이지), 사용자 설명서 (36 페이지), 사용자 설명서 (32 페이지), 매뉴얼 (36 페이지), 사용 설명서 (48 페이지), 사용 설명서 (36 페이지), 매뉴얼 (24 페이지), 설치 지침 매뉴얼 (36 페이지), 매뉴얼 (20 페이지), 매뉴얼 (44 페이지), 사용자 설명서 (36 페이지), 매뉴얼 (40 페이지), 매뉴얼 (40 페이지), 사용자 설명서 (20 페이지), 매뉴얼 (37 페이지), 빠른 시작 매뉴얼 (16 페이지), 매뉴얼 (20 페이지), 매뉴얼 (20 페이지), 매뉴얼 (36 페이지), 매뉴얼 (21 페이지), 빠른 시작 매뉴얼 (8 페이지), 매뉴얼 (40 페이지), 매뉴얼 (20 페이지), 매뉴얼 (32 페이지), 매뉴얼 (36 페이지), 매뉴얼 (17 페이지)

IKEA KULINARISK 매뉴얼
ENGLISH
3. Touch any symbol to turn off the signal.
4. Wipe out the appliance with a soft cloth.
Remove the water from the steam
generator.
Let the appliance dry fully with the door
open for approximately 1 hour.
To speed up the drying you can close the
door and heat up the appliance with the
function: True Fan Cooking at temperature
150°C for approximately 15 minutes.
Steam generation system
Caution! Dry the steam generator
after each use. Remove the water
with the sponge.
Remove the limescale with water
and vinegar.
Caution! Chemical de-scaling
agents can cause damage to the
enamel. Follow the instructions of
the manufacturer.
1. To clean the water drawer and the steam
generator, put the water and vinegar
mixture (approximately 250 ml) through
the water drawer into the steam
generator. Wait for approximately 10
minutes.
2. Remove the water and vinegar with the
sponge.
3. Put clean water (100 - 200 ml) into the
water drawer to flush the steam
generation system.
4. Remove the water from the steam
generator with the sponge and rub it dry.
5. Keep the door open to let the appliance
dry fully.
Removing and installing the door
You can remove the door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
Warning! The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on the
two door hinges.
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each
side and pull it away from the oven at an
upwards angle.
5. Put the door with the outer side down on
a soft cloth on a stable surface.
6. Hold the door trim (B) on the top edge of
the door at the two sides and push
inwards to release the clip seal.
2
B
7. Pull the door trim to the front to remove
it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully.
When the cleaning is completed, do the
above steps in the opposite sequence. Install
the smaller panel first, then the larger and
the door.
A
A
1
24