Frigidaire FFC0522DW0 사용 및 관리 매뉴얼 - 페이지 4

{카테고리_이름} Frigidaire FFC0522DW0에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Frigidaire FFC0522DW0 12 페이지. 134a series
Frigidaire FFC0522DW0에 대해서도 마찬가지입니다: 공장 부품 카탈로그 (7 페이지)

페이지 인쇄

First Steps

AIR SPACE

Installation

FL_RC

LE_/ELING FEET

Unpackingand Leveling - Upright Freezers

clo_ and sQal pml_r _

CO NOT let

food packages eadendpast the front

of shdve_

Shelf Front

Before

starting

the freezer,

follow these

important

first

steps:

Installation

• Choose a place that is near a grounded electrical outlet.

• The freezer should be located where surrounding temperatureswill

not exceed

110°F (43°C). Temperatures of 32°F (0°C) and below will NOT affect freezer

operation. Additional compressor heaters are not recommended.

• AIIowspacearoundtheunitforgoodaircirculation.Leavea3inch(75mm)space

on all sides of the freezer for adequate circulation.

Leveling

The freezer must have all bottom corners resting firmly on a solid floor The floor

must be strong enough to support a fully loaded freezer. NOTE: It is VERY

IMPORTANT for your freezer to be level in order to function properly. If the freezer

is not leveled du ring installatioin,the door may be misaligned and not close or seal

properly, causing cooling, frost, or moisture problems.

To Level Upright Unit:

After discarding crating screws and wood base, use a carpenter's level to level the

freezer from front-to-back. Adjust the plastic leveling feet in front, ½ bubble higher,

so that the door closes easily when left halfway open.

To Level Chest Unit:

If needed, add metal or wood shims between feet pads and floor

Cleaning

• Washanyremovableparts, thefreezerinterior,

andexteriorwithmilddetergent

and warm water. Wipe dry. DO NOT USE HARSH CLEANERS ON THESE

SURFACES.

• Do not use razor blades or other sharp instruments, which can scratch the

appliance surface when removing adhesive labels Any glue left from the tape

can be removed with a mixture of warm water and mild detergent, or touch the

residue with the sticky side of tape already removed. DO NOT REMOVE THE

SERIAL PLATE.

DOOR REMOVAL

(UPRIGHT MODELS)

If door must be removed,

(UNPLUG

THE UNIT.)

1. Gently lay freezer on its back, on a ru! or blanket.

2. Remove two base screws and base

Base

panel. Remove wire from clips on

Panel

bottom of cabinet. (Figure 1)

3. Unplug connector, if required, by

holding the cabinet connector in

place, and pulling door connector

out. (Figure 1)

4. Remove bottom hinge screws.

(Figure 1)

5. Remove plastic top hinge cover.

6. Remove screws from top hinge.

7. Remove top hinge from cabinet.

8. Remove door and bottom hinge

from cabinet.

9. To replace door, reverse the above

order and securely tighten all screws to prevent hinge slippage.

LID REMOVAL

(CHEST MODELS)

See Instructions on Hinge label.

(UNPLUG THE UNIT.)

Base Panel Screws

4inge Screws

Figure 1

Cabinet Connector