Green Cubes Lithium Safeflex Series 빠른 시작 매뉴얼
{카테고리_이름} Green Cubes Lithium Safeflex Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Cubes Lithium Safeflex Series 2 페이지.
페이지 인쇄QuickStart
Guide
Welcome to the world of
lithium-ion
Green Cubes SAFEFlex lithium-on batteries are safe, reliable, and
provide exceptional cycle life and cost of ownership. This guide will
help you understand the basics of storing, installing and operating
your new Green Cubes SAFEFlex lithium-ion battery. Please read
through this guide and contact us if you have any questions.
Safety and Precautions
•
Battery should be handled and installed by a trained
professional with proper lifting straps and equipment rated
for weight listed on data plate.
•
Prior to servicing, the battery must be keyed off and
disconnected from truck and/or charger.
•
Battery is only to be opened by trained professional.
•
Cell tops must be insulated before performing all service work.
•
Tools must be insulated to protect battery against short
circuits during servicing.
Installation
The battery should be installed in the battery compartment by a
trained professional using a forklift and lifting straps. In addition,
there are cutouts in the battery case that must be used when
lifting the battery. The service weight of the battery is printed
on the data plate. Make sure your equipment is properly rated to
handle the battery weight.
Main Power Connection
Once installed, the main power connection should then be
connected to the truck and will be either a Euro or SB style
connector (shown below).
Euro Connector
SB Connector
Truck- Battery Data Connection
In some cases, the battery and truck will have a separate data
connection that must be connected as well. The data connection
is required on some trucks to provide accurate battery discharge
indicator reporting and/or Early Warning System (EWS) information.
If a data connection is required, the battery will not supply power
to the truck until it is properly connected. If there is no data
connection, then a battery discharge indicator (BDI) is required.
On/Off Switch
The on/off switch should be easy to locate on
the outside of the battery. To turn the battery
on, press the switch. The line designates the
on position and the circle designates off.
If the battery is being stored or waiting for
deployment in a truck, make sure it is turned off until put into use.
The Battery Management System draws a small amount of power
and will slowly discharge the battery over time. Turning the battery
off prevents the possibility of overdischarge.
Battery Discharge Indicator
If there is no data connection to the truck, the battery requires a
Battery Discharge Indicator (BDI). In some batteries the BDI will be
integrated into the battery. If the BDI is not integrated an external
BDI must be installed in a location that is easily seen by the driver.
In some applications there will be a GCT BDI and a data connection
to the truck.
The BDI displays useful information for the driver, along with error
codes. The default view shows the state of charge, the pack voltage,
and the current draw or charge.
On/Off Switch
(shown in the
"Off" position)