ENGLISH
Once installed, packaging waste (plastic,
styrofoam parts etc.) must be stored out
of reach of children - risk of suffocation.
The appliance must be disconnected from
the power supply before any installation
operation - risk of electrical shock. During
installation, make sure the appliance
does not damage the power cable - risk of
fire or electrical shock. Only activate the
appliance when the installation has been
completed.
Carry out all cabinet cutting works
before fitting the appliance in the furniture
and remove all wood chips and sawdust.
Do not obstruct the minimum gap
between the worktop and the upper edge
of the oven - risk of burn.
Do not remove the oven from its
polystyrene foam base until the time of
installation.
After installation, the bottom of the
appliance must no longer be accessible -
risk of burn.
Do not install the appliance behind a
decorative door - risk of fire.
ELECTRICAL WARNINGS
The rating plate is on the front edge of
the oven (visible when the door is open).
It must be possible to disconnect
the appliance from the power supply by
unplugging it if plug is accessible, or by a
multi-pole switch installed upstream of the
socket and the appliance must be earthed,
in conformity with national electrical safety
standards.
Do not use extension leads, multiple
sockets or adapters. The electrical
components must not be accessible to the
user after installation.
Do not use the appliance when you are wet
or barefoot.
Do not operate this appliance if it has
a damaged power cable or plug, if it is
not working properly, or if it has been
damaged or dropped.
If the supply cord is damaged, it must
be replaced with an identical one by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a
hazard - risk of electrical shock.
In case of replacement of power cable,
contact an authorized service center.
16
페이지 인쇄