CenturionPro DBT 4 소유자 매뉴얼 - 페이지 8

{카테고리_이름} CenturionPro DBT 4에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CenturionPro DBT 4 16 페이지.

페이지 인쇄

LOAD

Remove clear Tumbler Lid from front of

Tumbler. Hold drum and pull out Plunger

and pivot drum into a upward facing posi-

tion, replace Plunger. Load dried, prepped,

untrimmed plant material into the Tumbler.

For best efficiency, fill Tumbler 40-60% full

and run batches of similar material.

Empty Trim Tray:

Lift the Tray Stop on the front of the machine to release the Trim Tray. Slide Trim Tray out of slots, empty tray and replace.

IMPORTANT NOTE:

TRIM TRAY SERVES AS A COLLECTION MECHANISM AND AS A SAFETY GUARD. MACHINE SHOULD NOT BE RUN

WITHOUT TRIM TRAY IN PLACE AND TABS ORIENTED IN THE VERTICAL POSITION.

SERVICING YOUR TRIMMER

Proper maintenance is essential for safe, economical, and trouble free operation.

Other service tasks that are more difficult, or require special tools, are best handled by professionals and are normally performed by a Centurion Pro technician or other qualified mechanic.

The maintenance schedule applies to normal operating conditions. If you operate your trimmer under severe conditions, such as sustained high load or high temperature operation, or use

it in unusually wet or dusty conditions, consult your servicing dealer for recommendations applicable to your individual needs and use.

Remember that an authorized Centurion Pro servicing dealer knows your trimmer best and is fully equipped to maintain and repair it. To ensure the best quality and reliability, use only new,

Centurion Pro parts or their equivalents for repair and replacement.

NOTICE: Improper maintenance, or failure to correct a problem before operation, can cause a malfunction which can cause serious injury

or death. Always follow the inspection and maintenance recommendations and schedules in this owner's manual.

IMPORTANT NOTE:

SIDE DRIVE IS NOT WATERPROOF.

DO NOT GET WET.

1 855 535 0558

RUN

Re-apply clear Tumbler Lid. Pull out Plunger

and pivot Drum into a horizontal position.

Tighten Blade Sheet as required. Turn ma-

chine ON and allow to run for 1-15 minutes.

Check material every 2-5 minutes. For a

closer trim, continue running the DBT Model

4 until desired trim is accomplished.

cprosolutions.com

TRIMMING PLANT MATERIAL

EMPTY

Once desired trim is accomplished, remove

Trim Tray & Tumbler Lid, position separate

container (not included) to capture

processed material, pull out Plunger and

pivot drum to a downward facing position.

Processed material will be deposited in

container when correctly positioned.