Gamry Reference 3000 빠른 시작 매뉴얼 - 페이지 2
{카테고리_이름} Gamry Reference 3000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamry Reference 3000 16 페이지. Usb potentiostat installation
Gamry Reference 3000에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)
페이지 인쇄™
Reference 3000
Potentiostat/Galvanostat/ZRA Quick-Start Guide
Computer and Power Requirements
You must connect the Gamry Potentiostat and install the Gamry
Framework Version 5 software in the same computer. Your
Reference 3000 communicates using the Universal Serial Bus
(USB). This PC must meet the requirements below.
Hardware
•
A Windows-compatible personal computer
•
One available USB port, revision 2.0 (preferred) or 1.1.
•
Use the supplied certified USB interconnect cable with an A/B
connector configuration.
Software
•
®
®
Microsoft
Windows
Vista or Windows
bit versions
•
At least 512 MB of memory (1000 MB recommended) and
200 MB of available hard disk space
Power
•
Use the supplied AC to DC power brick.
2
Installed Potentiostat with Cell Cable Attached
®
XP, either 32-bit or 64-
Gamry Instruments, Inc. © 2008
Compatibility Between Software Versions
and Potentiostats
Gamry Version 5 software is compatible with all Gamry Potentiostats
in the current generation.
•
The Reference 3000™, Reference 600™ and Series G
Potentiostats work with Gamry Version 5 software only.
•
The PCI4/300™ and PCI4/750™ Potentiostats, and the FAS2™
Femtostat work with either Version 5 or Version 4 of the Gamry
software.
Earlier potentiostat generations (PC4, FAS1, and PC3 Potentiostats)
are not compatible with Version 5 Gamry software.
Authorization Codes and Serial Numbers
A sticker on the software license envelope contains the ten-digit
Authorization Codes needed to install (or upgrade) the Gamry
software.
Before you can use a Gamry software package, you must enter the
Authorization Code to access the software. Authorization Codes are
tied to the five-digit serial number of a specific potentiostat. The
serial number of each Reference 3000 Potentiostat is on a plate on
the bottom of the unit.
If you bought more than one potentiostat (to be installed in more than
one PC), each potentiostat will be packed in a separate carton with
its own controller board and software Authorization Codes. Keep the
contents of each carton together. Authorization Codes are valid only
for the potentiostat shipped with the codes.
988-00008