IKEA NUTID 설치 및 사용자 지침 매뉴얼 - 페이지 11

{카테고리_이름} IKEA NUTID에 대한 설치 및 사용자 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA NUTID 46 페이지. French door refrigerator
IKEA NUTID에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지), 설치 매뉴얼 (12 페이지), 조립 지침 매뉴얼 (12 페이지)

페이지 인쇄

Door Closing and Door Alignment

The base grille covers the leveling screws and roller assemblies

located at the bottom of the refrigerator cabinet below the

freezer door or drawer. Before making adjustments, remove the

base grille and move the refrigerator to its final location.

1. Remove the two screws fastening the base grille to the

cabinet, and set the screws aside. Grasp the grille and pull

it toward you.

2. Move the refrigerator to its final location.

NOTE: To allow the refrigerator to roll easier, raise the

leveling legs off the floor by turning the leveling screws

counterclockwise. The front rollers will be touching the floor.

3. So the doors will close easier, use a 1⁄4" hex driver to turn

both leveling screws clockwise. This will raise the front of

the refrigerator tilting it slightly downward to the rear. Turn

both leveling screws the same amount.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the leveling screws. This

makes it easier to turn the screws.

A. Leveling screw

4. Open and close the doors to make sure they close as easily

as you like. If not, increase the tilt by turning both leveling

screws clockwise. It may take several turns of the leveling

screw to allow the doors to close easier.

5. Check for door alignment. If one door is lower than the

other, adjust the leveling screw, on the lower side of

the refrigerator. Using a 1⁄4" hex driver, turn the screw

clockwise to raise that side of the refrigerator until the doors

are aligned. It may take several turns of the leveling screw

to raise the refrigerator.

¹⁄₄"

NOTE: Having someone push against the top of the

refrigerator takes some weight off the leveling screws. This

makes it easier to turn the screws.

6. Make sure the refrigerator is steady. If the refrigerator

seems unsteady or rolls forward when the door or drawer is

opened adjust the leveling screws. Using a 1⁄4" hex driver,

turn the leveling screw on each side clockwise until the

rollers are up and the leveling feet are firmly against the

floor.

NOTE: Having someone push against the top of the

refrigerator takes some weight off the leveling screws. This

makes it easier to turn the screws.

7. Replace the base grille by aligning the holes in the grille

with the holes in the cabinet and fasten using the screws

removed in Step 1.

REFRIGERATOR USE

Opening and Closing Doors

(French door models)

There are two refrigerator compartment doors. The doors can

be opened and closed either separately or together.

There is a vertically-hinged seal on the left refrigerator door.

When the left side door is opened, the hinged seal

■

automatically folds inward so that it is out of the way.

When both doors are closed, the hinged seal automatically

■

forms a seal between the two doors.

A. Hinged seal

¹⁄₄"