IKEA Oven 사용자 설명서 - 페이지 5

{카테고리_이름} IKEA Oven에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA Oven 7 페이지. Oven built in
IKEA Oven에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)

페이지 인쇄

61902017GB.fm Page 14 Wednesday, July 30, 2008 4:12 PM

MAINTENANCE

Care and maintenance

Clean the hob after each use in order to avoid damaging

the surface and to prevent the formation of baked-on

deposits which are difficult to remove. Before cleaning,

make sure the cooking zones are switched off and that the

residual heat indicator ("H") is not displayed.

• Never clean the hob with a steam cleaner!

• Periodically check for dust under the

appliance, near the cooling air inlet or the

outlet openings. This could hinder the

ventilation and cooling of the electronic

module and decrease the effectiveness of

the hob.

Troubleshooting Guide

• Before contacting After-sales Service:

• read and follow the instructions given in the section

"Operating instructions".

• Connect the hob to the electricity supply and check that

the supply has not been shut off.

ERROR CODE

The hob switches off

and after 30 seconds

emits an acoustic signal

every 4 seconds

The control panel switches off

C81, C82

because of excessively high

The connection voltage is

F42 or F43

F12, F21, F25, F36,

F37, F40, F47, F56,

F58, F60

Warning!

If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately from the

power supply.

After-sales Service

Before contacting After-sales Service:

• Try to solve the problem (see "Troubleshooting

Guide").

• Switch the appliance off, wait 30 seconds then switch it

on again. to see if the fault persists.

If after the above checks the fault persists, contact the

nearest After-sales Service.

DESCRIPTION

Continuous pressure on

Water or utensils on control panel

control panel area

The internal temperature of

electronic parts is too high

temperatures

The sensor detects a discrepancy

between the appliance voltage and

wrong

Call the After-Sales Service and specify the error code

To clean the hob, proceed as follows:

1. use a soft clean cloth, absorbent kitchen wipes or a

proprietary cleaner for glass ceramic hobs. Do not use

abrasive sponges and/or metal scouring pads.

2. Food spills should be cleaned off before they bake

onto the glass ceramic surface. Sugar and foods with a

high sugar content damage the glass ceramic surface

and must be immediately removed using a scraper for

glass. Glass scrapers have a very sharp blade and must

be handled with care.

3. Remove any stubborn food residues with a scraper or

proprietary detergents.

4. Salt, sugar and sand can scratch the glass ceramic hob:

clean up any such spills on the hob immediately.

• Clean the hob and dry it thoroughly.

• If, when the hob is switched on, alphanumeric codes

appear on the display, consult the following table for

instructions.

POSSIBLE CAUSES

Wait for the hob to cool down

Disconnect the hob from the

mains and check the electrical

that of the mains supply

Always provide:

• a brief description of the fault;

• the exact type and model;

• the service number (number after the word Service on

the rating plate) is located on the underside of the

cooktop or on the warranty booklet;

• your complete address and phone number.

If any repairs are required, please contact an authorized

After-sales Service as indicated in the warranty.

REMEDY

Clean the control panel

before using it again

connection