IKEA RAFFINERAD 매뉴얼 - 페이지 5

{카테고리_이름} IKEA RAFFINERAD에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA RAFFINERAD 44 페이지. Ovens
IKEA RAFFINERAD에 대해서도 마찬가지입니다: 소유자 매뉴얼 (24 페이지), 사용자 설명서 (44 페이지), 매뉴얼 (16 페이지), 매뉴얼 (20 페이지)

페이지 인쇄

ENGLISH

General Safety

• Only a qualified person must install this appliance and re-

place the cable.

• Internally the appliance becomes hot when in operation. Do

not touch the heating elements that are in the appliance. Al-

ways use oven gloves to remove or put in accessories or

ovenware.

• Do not use a steam cleaner to clean the appliance.

• Before maintenance cut the power supply.

• Do not use harsh abrasive cleaners or sharp metal scrapers

to clean the glass door since they can scratch the surface,

which may result in shattering of the glass.

• To remove the shelf supports first pull the front of the shelf

support and then the rear end away from the side walls. In-

stall the shelf supports in the opposite sequence.

• If the supply cord is damaged, it must be replaced by the

manufacturer, an authorized Service or similarly qualified

persons in order to avoid a hazard.

• Ensure that the appliance is switched off before replacing the

lamp to avoid the possibility of electric shock.

Safety instructions

Installation

Warning! Only a qualified person must

install this appliance.

• Remove all the packaging.

• Do not install or use a damaged appli-

ance.

• Obey the installation instruction supplied

with the appliance.

• Always be careful when you move the

appliance because it is heavy. Always

wear safety gloves.

• Do not pull the appliance by the handle.

• Make sure that the appliance is installed

below and adjacent safe structures.

• The sides of the appliance must stay ad-

jacent to appliances or to units with the

same height.

Electrical connection

Warning! Risk of fire and electrical

shock.

• All electrical connections should be made

by a qualified electrician.

• The appliance must be earthed.

• Make sure that the electrical information

on the rating plate agrees with the power

supply. If not, contact an electrician.

• Always use a correctly installed shock-

proof socket.