Gamry Reference 3000 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} Gamry Reference 3000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamry Reference 3000 16 페이지. Usb potentiostat installation
Gamry Reference 3000에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (4 페이지)

페이지 인쇄

™

Reference 3000

Potentiostat/Galvanostat/ZRA Quick-Start Guide

Found New Hardware (Windows Vista)

Found New Hardware (Windows XP)

Make Sure Potentiostat Has Been Detected by

Windows

Because you installed the Gamry software before you

installed the potentiostat, the potentiostat should be

recognized automatically, and the correct software drivers

installed.

To check hardware detection:

Completing Software Setup

Assign Label (Name) to Potentiostat

The potentiostat's Device Settings window opens

automatically the first time the PC is started after the

Framework software has been installed successfully. This

window shows the model number of the potentiostat, followed

by its serial number.

Use this window to specify the text label that will be used to

identify the potentiostat on Gamry software screens. The

maximum size of a label is ten characters (including spaces).

To assign a name to a potentiostat, type the name in the

Label field in the Device Settings window.

Do not click on Finish. You must enter Authorization Codes

as described below.

With the Gamry CD still in the drive, turn on the PC.

After the operating system starts, you will see a

message that an instrument from the Reference Family

Instrument has been detected.

If running Windows Vista, the "Found New Hardware"

screen appears. Select "Locate and install driver

software". You may then need to acknowledge a

security prompt on the next screen.

If running Windows XP, the "Found New Hardware

Wizard" asks questions about the software installation.

When asked about connecting to the Internet, select

"No". When asked about searching the computer to load

drivers automatically, select "Yes". After working

through the wizard, go to the next step.

If the Reference Family of instruments was detected,

remove the Gamry CD from the drive.

If you see a message that refers only to "USB Device",

the operating system could not find the Gamry drivers.

Try this: Unplug the USB cable connecting the

Reference 3000, shut down Windows and turn off the

PC. Power up the PC and wait until Windows has

completed normal startup. Shut down Windows and turn

off the PC. Reinsert the USB cable. Power up the PC.

988-00008