AGUZZO Streamline S75L533P 설치 지침 - 페이지 2

{카테고리_이름} AGUZZO Streamline S75L533P에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. AGUZZO Streamline S75L533P 5 페이지. 304 stainless steel heated towel rail

Key Specifications

Construction: 304 Stainless Steel – corrosion protection – no chrome

Electrical - Tested and certified to comply with AS/NZ: 60335 and c-tick requirements

IP55 Rated – water splash and spray proof

Power supply – 220-240 Vac, 50/60Hz

§  Eliminate choking and suffocation hazards for young children by removing and safely

discarding all protective packaging and the protetive cover on the power plug

§  This appliance operates at a temperature that is hot but not scalding on touch (up to

55°C). Rises in ambient temerature and the insulation effect of towels can cause the

operating temperature to rise. Young children and infirm persons should be supervised

near this appliance

§  Do NOT use this towel rail to dry damp or wet clothing or articles that have been in

contact with oil, petroleum based products, or dry cleaning fluids.

§  Use this appliance ONLY on the voltage specified on its electrical specification label

§  Do NOT use this appliance other than for its intended use

§  IPX5 rated to withstand water splashes and sprays. Do NOT immerse in liquid

§  Do NOT allow the power supply cord to come into contact with any heated surfaces.

§  Carefully read all instructions before installation and operation

§  If you are hard-wiring or connecting to a switch/controller this appliance MUST be

installed by a qualified and licenced electrician in accordance with relevant wiring rules

(AS/NZS 3000:2000 in Australia and New Zealand)

§  It MUST be installed so the bottom rail is at least 600mm from the floor.

§  It MUST be installed at least 1.7m from combustible materials such as drapes and

furnishings

§  The appliance is supplied with an earthed 3-core supply cord and plug. This cord and

plug MUST be positioned so it is not subject to splashing water or ingress of msoiture.

§  Install with a suitable switch or controller:

-  Plug into a power point with a switch

-  Hardwire to a wall switch

-  Hardwire to a controller (such as a timer switch or thermostat switch)

§  Do NOT install or operate with a damaged cord or plug.

§  Do NOT cover the cord and ensure it is arranged so it does not pose a risk

§  Do NOT install outdoors

IMPORTANT

Retain

this instruction booklet

for future reference