IKEA DW45 소유자 매뉴얼 - 페이지 19
{카테고리_이름} IKEA DW45에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA DW45 28 페이지. Renlig
IKEA DW45에 대해서도 마찬가지입니다: 조립 설명서 (20 페이지)
ENGLISH
Place the appliance on the floor and install it
under a counter (kitchen worktop or sink).
If a repair is necessary, the appliance must
be easily accessible for the engineer.
Put the appliance adjacent to a water tap
and a drain.
Water connection
This appliance has a special inlet hose
for water stop later defined as aqualock.
Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an
external thread of 3/4".
Caution! Do not use connection hoses
from an old appliance.
Caution! If you connect the appliance
to new pipes or pipes that are not used
for a long time, we recommend to run the
water for some minutes before you connect
the inlet hose.
Aqualock inlet hose
The inlet hose is a high pressure resistant. It
can hold pressure at maximum 6 MPa. From
external the inlet hose has a sheathing
against eventual damages. If the inner hose
breaks, the water that is in the hose will be-
came dark. You can see it across the special
transparent sheathing. Turn off the water tap
immediately and contact the After Sales Serv-
ice.
For the venting of the dishwasher only water
fill, water drain and power supply cable open-
ings are necessary.
A
B
The aqualock inlet
hose is installed with
a safety device to
prevent
accidental
loosening. To discon-
nect the hose:
• Press the lever ( B ).
• Turn the retaining
ring ( A ) anticlock-
wise.
19
Turn the inlet hose to
the left or the right
to suit the installa-
tion. Tight the lock-
nut correctly to pre-
vent water leaks.
If you use a in-
let hose exten-
sion
the
total
reached length must
be no longer than 4
metres.