Gamut D 3I 사용자 설명서 - 페이지 10

{카테고리_이름} Gamut D 3I에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamut D 3I 16 페이지. Dual mono preamplifier

D 3i

To enable this function, you must do two things:

First of all: Press the little switch labeled Bypass

downwards, it is located at the back of the D 3i

just beside the CD input.

Secondly:

While the CD input source has been chosen,

you press the push knob just below the display

Bypass.

Now the dot below CD will move below Bypass

and the signal goes directly into the power

ampliﬁ er. Please note that the volume control

of the D 3i is no longer in use and if you are not

very careful you might experience a full level

output!

When the Bypass function has been enabled the

source selecting route is changed. Instead of

selecting CD input the Bypass dot will light. See

illustration:

Connecting to a surround Processor

HTH Direct function is intended for cases where

the D 3i is connected to a surround preampliﬁ er

or processor. Enable the Direct function by push-

ing the small switch situated at the left side of

the HTH input terminals on the backside of the

preampliﬁ er.

The Direct function of this input will bypass the

volume control and lead the signal directly to

the output of the D 3i. This converts the D 3i

into a non-amplifying and non-level adjusting

device. Leading the two front channels of a sur-

round system directly into your power ampliﬁ er.

Please note: While the HTH Direct is enabled

and the HTH input is selected, the volume

control volume will be disabled to avoid conﬂ ict

with other remote control systems.