Gamut D200i 사용자 설명서 - 페이지 3

{카테고리_이름} Gamut D200i에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gamut D200i 12 페이지. Dual-mono power amplifiers

SAFETY INSTRUCTIONS:

Never push anything into holes or slots in the case - this could result in an electric shock and could

cause damage of the set.

Never guess or take chances with electrical equipment of any kind - it is better to be safe than

sorry.

Warning: To prevent re or shock hazard do not expose this appliance to rain or moisture

No user serviceable parts inside. Refer servicing to a quali ed technician. Never remove covers

unless quali ed to do so. This unit contains dangerous voltages.

DO read the user's guide before you attempt to use this equipment.

DO ensure that all electrical connections are properly set in accordance with the manufacturer's

instructions (this includes the mains plug, extension leads and interconnections between pieces

of equipment).

DO check that the mains fuse rating is set correct for your local mains voltage.

DO NOT obstruct the necessary all-around ventilation: Especially DO NOT place the set close to

curtains or on soft furnishing such as carpets. Overheating can cause unnecessary damage and

shorten the life of the set.

DO NOT switch the ampli er on, then o , then on again quickly. The blue light must disappear

completely before you switch on again. Only switch on and o using the power switch.

DO NOT unplug the mains cables while they carry current. This will corrode and damage the surface

of the metal of the mains plugs and sockets. This can cause reduced sound quality and electrical res.

The mains switches have special metals in the contact points selected for handling high in-rush

currents, as well as to break large currents. Plugs and sockets are not made of such metals.

DO NOT use the 'direct' speaker output for tests with square waves or sine waves and a capacitor

across the output terminals, as you may damage the ampli er.

DO NOT connect output ground to input ground. Do not connect any output grounds together.

DO NOT connect headphones to this ampli er without using protecting resistors.

Make sure that you do not let any tiny part of the speaker cable going to a terminal touch the other

terminals. Only connect this ampli er to loudspeakers, and only one loudspeaker on each channel.

Do not connect the output of this ampli er to another ampli ers outputs or inputs.

DO NOT connect a red terminal to another red terminal

DO NOT bridge the ampli er