Century Bassinet 10-440 Series 사용 설명서 - 페이지 4
{카테고리_이름} Century Bassinet 10-440 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Century Bassinet 10-440 Series 8 페이지.
페이지 인쇄
A S S E M B LY
For proper stand assembly, follow the
instructions for your model.
Model 10-440 Series Stand Assembly:
1
Using screws, attach four (4) cross
braces to one set of curved legs.
Do not over tighten screws.
2
Using screws, attach four (4)
cross braces and spacers to
second curved leg section.
3
With casters on floor, insert
ends of Cradle Support Rod
through holes in top of
curved leg section.
NOTE: Curved edge of
Cradle Support Rod must be
angled outward as shown.
4
Screw knobs over ends of
Cradle Support Rod
until knob is tight against legs.
Hand tighten only.
Repeat steps 3 & 4 for second
curved leg section.
3
Cross
Brace
Cradle
Support Rod
Model 10-450 & 10-460 Series Stand
Assembly:
1
Insert cross braces into side of leg with
larger hole and secure with screws.
Do not over tighten.
CAUTION: Inserting cross braces
in wrong side of leg (small hole side)
can cause cross braces to break
during use.
2
Using screws, attach four (4) cross
braces to second curved leg section
with screws.
CAUTION: Make sure cross braces
go into side of leg with larger
hole.
3
Hook one end of rod over
small indentation at end of
cross brace (A).
4
Hook end of rod over opposite
side of cross brace (B).
Repeat steps 3 & 4 for opposite
end.
5
With casters on floor, insert
ends of Cradle Support
Rod through holes in top of
curved leg section.
NOTE: Curved edge of
Cradle Support Rod must be
angled outward as shown.
Make sure rod installed in
steps 3 & 4 remains hooked
on cross braces before
securing cradle supports.
6
Screw knobs over threaded
ends of Cradle Support Rod
until knob is tight against legs.
Hand tighten only.
Repeat steps 5 & 6 for opposite
end.
Large
Hole Side
Cross
Brace
Rod
A
Rod
B
Cradle
Support Rod