IKEA ID5HHEXVS00 사용자 지침 - 페이지 5
{카테고리_이름} IKEA ID5HHEXVS00에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA ID5HHEXVS00 28 페이지.
페이지 인쇄NOTE: Tighten t henutbyhand. Then tighten i twithawrench
twomore turns. Donotovertighten.
2. Flush thewater system. See "Prepare theWater System" or
"Water and IceDispensers."
NOTE: Allow 24hours t oproduce thefirstbatch ofice. A llow
3days tocompletely fillicecontainer.
REFRIGERATOR USE
A
B
C
D
E
F
G
A. Refrigerator water tubing
B. Nut (provided)
C. Bulb
D. Coupfing (purchased)
E. Ferrule (purchased)
F Nut (purchased)
G. Household
water line
4. Turn shutoff valve ON.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
Style 3
1. Unplug refrigerator or disconnect power.
2. Remove and discard the black nylon plug from the gray water
tube on the rear of the refrigerator.
3. Thread the provided nut onto the water valve as shown.
NOTE: Tighten the nut by hand. Then tighten it with a wrench
two more turns. Do not overtighten.
A
t/
II
B
A. Bulb
B. Nut (provided)
4. Turn shutoff valve ON.
5. Check for leaks. Tighten any nuts or connections (including
connections at the valve) that leak.
Complete the Installation
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension
cord.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
eCon't
s
For your convenience, your refrigerator controls are preset at the
factory. When you first install your refrigerator, make sure that the
controls are still preset. The Refrigerator Control and the Freezer
Control should both be set to the "mid-settings."
FREEZER
REFRIGERATOR
•
o
2
4
COLD l@s
COLDER
2@t.
COLD 1
s COLDER
IM PORTANT:
Your product will not cool when the REFRIGERATOR Control
is set to OFE
The Refrigerator Control adjusts the refrigerator compartment
temperature. The Freezer Control adjusts the freezer
compartment
temperature. Settings to the left of the mid-
setting make the temperature less cold. Settings to the right of
the mid-setting
make the temperature colder.
Wait 24 hours before you put food into the refrigerator. If you
add food before the refrigerator has cooled completely, your
food may spoil.
NOTE: Adjusting the Refrigerator and Freezer Controls to a higher
(colder) than recommended
setting will not cool the
compartments
any faster.
Adjusting Controls
Give the refrigerator time to cool down completely before adding
food. It is best to wait 24 hours before you put food into the
refrigerator. The settings indicated in the previous section should
be correct for normal household refrigerator usage. The controls
are set correctly when milk or juice is as cold as you like and when
ice cream is firm.
Turn the control right (clockwise) to make the compartment colder.
Turn the control left (counterclockwise)
to make it less cold. To
turn the cooling system off, turn the Refrigerator Control
counterclockwise
until it reaches the OFF position.
If you need to adjust temperatures
in the refrigerator or freezer,
use the settings listed in the chart below as a guide. Wait at least
24 hours between adjustments.
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR too warm
REFRIGERATOR Control
one setting higher
FREEZER too warm/
FREEZER Control
too little ice
one setting higher
REFRIGERATOR too cold
REFRIGERATOR Control
one setting lower
FREEZER too cold
FREEZER Control
one setting lower
1. Plug into a grounded 3 prong outlet.