IKEA IK8FXNGFDM02 설치 및 사용자 지침 매뉴얼 - 페이지 16
{카테고리_이름} IKEA IK8FXNGFDM02에 대한 설치 및 사용자 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IK8FXNGFDM02 18 페이지.
페이지 인쇄
If you experience
Possible Causes and/or Recommended Solutions
Temperature is
New installation - Allow 24 hours following installation for the refrigerator to cool completely.
too warm
Door(s) opened often or not closed completely - Allows warm air to enter refrigerator. Minimize door
openings and keep doors fully closed.
A large amount of warm food has been recently added - Allow several hours for refrigerator to return to
normal temperature.
Check that the Temperature controls are set correctly for the surrounding conditions - Adjust the
controls to one setting colder. Check temperature in 24 hours. See "Using the Controls."
There is interior
Humid room - Contributes to moisture buildup in the refrigerator.
moisture buildup
Door(s) opened often or not closed completely - Allows humid air to enter the refrigerator. Minimize door
NOTE: Some
openings and keep door fully closed.
moisture buildup is
normal.
The ice maker is
The ice maker is not connected to a water supply - Connect refrigerator to water supply and turn water
not producing ice
shut-off valve fully open.
or not enough ice
A kink in the line can reduce water flow - Straighten the water source line.
(on some models)
Ice maker is not turned on - Make sure the ice maker wire shut-off arm or switch (depending on model) is in
the On position.
New installation - Wait 24 hours after ice maker installation for ice production to begin. Wait 3 days for full
ice production.
Large amount of ice recently removed - Allow sufficient time for ice maker to produce more ice.
Ice cube jammed in the ice maker ejector arm - Remove ice from the ejector arm with a plastic utensil.
A reverse osmosis water filtration system connected to your cold water supply can decrease water
pressure - See "Water Supply Requirements."
The ice cubes are
The water valve is not completely open - Turn the water shut-off valve fully open.
hollow or small
A kink in the line can reduce water flow - Straighten the water source line.
(on some models)
A reverse osmosis water filtration system connected to your cold water supply can decrease water
NOTE: This is an
pressure - See "Water Supply Requirements."
indication of low
water pressure.
If questions regarding water pressure remain, call a licensed, qualified plumber.
Off-taste, odor, or
New plumbing connections can cause discolored or off-flavored ice - Discard the ice and wash the ice
gray color in the
storage bin. Allow 24 hours for the ice maker to make new ice and discard the first 3 batches of ice produced.
ice (on some
Ice stored too long can develop an off-taste - Discard ice. Wash ice bin. Allow 24 hours for ice maker to
models)
make new ice.
Food odor transferring to ice - Use airtight, moisture proof packaging to store food.
There are minerals (such as sulfur) in the water - A water filter may need to be installed to remove the
minerals.
The following accessories are available for your refrigerator. To
order an accessory, call 1-866-664-2449, and ask for the part
number listed below or contact your authorized Whirlpool dealer.
affresh
Stainless Steel Cleaner:
®†
In U.S.A., order Part #W10355016
In Canada, order Part #W10355016B
†
affresh is a registered trademark of Whirlpool U.S.A.
®
16
ACCESSORIES
affresh
Stainless Steel Wipes:
®
In U.S.A., order Part #W10355049
In Canada, order Part #W10355049B
affresh
Kitchen & Appliance Cleaner:
®
In U.S.A., order Part #W10355010
In Canada, order Part #W10355010B