Green Frog Designs Chicken Run 4x2 매뉴얼 - 페이지 6

{카테고리_이름} Green Frog Designs Chicken Run 4x2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Frog Designs Chicken Run 4x2 17 페이지.

페이지 인쇄

2x2 model

4x2 model

6x2 model

4x4 model

6x4 model

Door

Prior to assembly, check that you have all the required parts. Please be aware that, being a recycled material, some minor

surface blemishes or defects may have occurred during manufacture. These will not affect the functionality of your product.

Trim any excess plastic using sand paper or a sharp knife. (NOTE: Be careful to cut away from yourself.)

Please state the part number, quantity missing, your phone number and your full postal address.

Spare parts are available to order online via our website: www.greenfrogdesigns.co.uk

These instructions are generic, so a little common sense is needed when interpreting them. Some frames have parts not used

by others.

Before you start, it is important to decide from which upright your door is to be hung (left or right) and how it is to be opened

(inwards or outwards). We generally recommend hanging it from a corner upright and opening outwards. However, if an

electric fence is to be used, the door must open inwards (to avoid electric shocks).

This User Guide assumes an inwards opening door, hung from the right hand upright of the front panel. For other

configurations, adjust the frame and the position and orientation of the hinges and door catch accordingly. Don't worry if you

make a mistake, as you can knock the frame apart and change the position of hinges and catches quite easily (though it is

always easiest if you plan carefully and get it right first time!).

Build the frame as close as possible to or, ideally, in its desired final location. While 2x2 and 2x4 frames can be moved without

too much difficulty, it can distort the frame and cause damage, so we don't recommend moving them. Larger frames are not

really suitable for moving at all (unless you have a lot of helping hands) and need to be assembled exactly in their final position.

While it is possible for one person to assemble this product, it is much easier if you have an assistant.

Attachment of the optional supports for electric fence wires is covered in a separate section at the end of this User Guide.

When Electric Fencing is being used, the Corner Brackets are best fitted when the frame is being constructed, but they are not

shown in the Frame Layout drawings.

Please take special care when cutting wire mesh. It is easy to leave very sharp points, even if the 'vertical' wire appears to be cut

very close to the 'horizontal' wire. Use of leather gloves and eye protection is recommended. Also, be aware that the rolls of wire

have a tendency to spring back into a roll, which can mean fast moving sharp points. Children should be kept well clear.

Printed on recycled paper

Width (mm)

2050

4075

6100

4075

6100

650

TOOLS REQUIRED

Sharp knife (e.g. Stanley Knife)

Large size cross-head (Phillips/Pozidriv) screwdriver

10mm ring spanner (or socket wrench or adjustable spanner)

Rubber or wooden mallet

Leather gloves and eye protection (recommended)

PRE-ASSEMBLY CHECKS

If any parts are missing, please email [email protected]

ASSEMBLY OVERVIEW

IMPORTANT NOTE REGARDING ELECTRIC FENCE SUPPORTS (OPTIONAL)

IMPORTANT SAFETY NOTE

DIMENSIONS

Depth (mm)

2050

4075

25 (frame only)

Side-cut pliers or snips

Metal file

SPARE PARTS

Height (mm)

2050

1850

Page 6 of 17