Green Frog Designs Chicken Run 6x4 매뉴얼 - 페이지 12

{카테고리_이름} Green Frog Designs Chicken Run 6x4에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Green Frog Designs Chicken Run 6x4 17 페이지.

Assemble the door by inserting two Flat Tee Joints into

the 600mm Door Bar and tapping them home with a

mallet. Then tap home the two Door Frames.

Place the assembly over the central 600mm Door Bar

(from step 1), attach the Door Catch Lower and fix it in

place with Pi Clips. It should be free to slide along the bar.

Using two 30mm M6 Bolts, Nylock Nuts and Washers,

attach the Door Lock. Tighten the nuts until the Door

Lock will move with slight pressure.

Printed on recycled paper

Fix the Door Catch Sides into the Door Catch Upper

using Pi Clips. The small holes must be at the bottom.

Using a 40mm M6 Bolt and Nylock Nut, fix one end of

the Spring in position between the Door Catch Sides,

underneath the assembly. When fully screwed home, the

bolt will just enter the opposite hole. Attach the other end

of the Spring to the door frame with a Cable Tie.

Fix the Door Hinge Part A and 2x Door Hinge

Part B into one of the Door Hinge Sides as shown, and

secure with Pi Clips.

Page 12 of 17